2909
Retractable Operation Instruction
Parts explanation
：
◎
Multi-Application:
A domestic LCD Television, Laptop, Projector….etc.
◎
Lock slot specification:
（
1
）
Apply to 7mm x 3mm ~ >7mm x 3.6mm (as drawing to the right)
（
2
）
An extra lock slot located in a side of lock cassette.
※
NOTE:
Please make sure the application slot is suitable for above mentioned lock slot specification in case of any damage caused.
◎
Locking steps.
(1)Cable around the immovable article:
Find out a lock hole (if not, find a flat area) -> press the button (1)
+
pull out the lockset (2). -> Before insert the end of application slot,
the cable should be around the immovable article and cross through the fitting hole of lock cassette (3). (P. 1)
(2)Unlocked modes:
P.2
：
Push bottom protrudes the lock barrel is un-locked.
P.3
：
Push bottom stays in the lock barrel is locked.
P.4
：
If push bottom stays locked, before insert in the end of application slot, you need to:
Holding the lock housing or lock buckle -> holding key handle -> insert key to the end and rotate the key to unlock the lockset-> push
bottom released (lock bottom jump out automatically.) -> Make a left turn -> withdraw key from the lockset-> unlock. (see P.2)
※
IMPORTANT:
when you try to release the push bottom if your hand do not hold the lock housing or lock buckle, the key will keep
doing idle-running in the lock barrel.
Covers
Lock slot
lockset
cassette
bottom
Parts name of
cassette
Push bottom
Cable
Lock housing
Buckle
Foam
Lock bolt
Connecting
Parts name of
lockset
(2)
(1)
(3)
Notebo
ok
Immovable article such as table…etc.,
P.1
(2) insert key to the
end and
rotate
P.4
(1) Holding the
lock housing or
lock buckle
P.2. Unlocked mode
Push bottom protrudes the
lock barrel in the meantime you could
lock anything which is having
7mmx3mm~7mmx3.6mm lock slot.
Push bottom has been
pushed down, no way to
push in again.
P.3. Locked mode
Connecting up
