c 2014 ABH Mfg., Inc.
printed in USA
R
O
www.abhmfg.com
E-mail: abhinfo@abhmfg.com
Architectural Builders Hardware Mfg., Inc.
1222 Ardmore Ave., Itasca, IL 60143
630.875.9900; FAX 800.9FAXABH (932.9224)
6800-3-04.DWG
6800-3
REVISED 09-16-14
USING FACE PLATE AS A TEMPLATE, MARK OUTLINE. ALSO
HOLES THRU. THEN DRILL 1" DIA. EDGE HOLE.
JAMB TO RECEIVE STRIKE BOX. (SEE FIGURE 3).
AT ALL TIMES WHILE DRILLING. DRILL 2-1/8" DIA. CROSS
BORE FIRST. NEXT, DRILL FOUR (4) 5/16" DIA. MOUNTING
MARK LOCATION OF TWO (2) ATTACHING SCREWS. REMOVE
NEXT, MORTISE DOOR EDGE 5/32" DEEP FOR FACE PLATE
MORTISE JAMB 3/32" DEEP FOR STRIKE. MORTISE
MAKING CERTAIN DRILL IS PERPENDICULAR TO THE DOOR
A. DRILL HOLES AS DIRECTED ON INSTALLATION TEMPLATE
MORTISE AND DRILL DOOR AND FRAME.
B. INSERT LATCH BOLT UNIT INTO HOLE IN EDGE OF DOOR.
C. DRILL PILOT HOLES FOR TWO (2) ATTACHING SCREWS.
D. DRILL PILOT HOLES FOR STRIKE SCREWS IN DOOR JAMB.
OUT SWINGING
OUTSIDE
DOOR JAMB
FIGURE 3
6800 LOW PROFILE PUSH/PULL LATCH
WOOD DOOR AND FRAME PREPARATION
A. USING A SQUARE, DRAW A HORIZONTAL LINE ON EDGE
ALSO MARK DOOR FRAME AT THIS SAME HEIGHT.
CROSS BORE. ALSO MARK LOCATION OF FOUR (4) 5/16"
B. USING INSTALLATION TEMPLATE, MARK LOCATION OF
VERTICAL CENTERLINE FOR 1" DIA. HOLE (SEE FIGURE 1).
MARK LOCATION OF TWO (2) ATTACHING SCREWS. (SEE
USING STRIKE AS A TEMPLATE, MARK OUTLINE. ALSO
(MEASURED FROM DOOR STOP OR SILENCER IF USED).
OF STRIKE, TAKE HALF OF THE DOOR THICKNESS
C. TO DETERMINE LOCATION OF VERTICAL CENTERLINE
OTHERWISE DIRECTED) ABOVE THE FLOOR. -OR-
DIA. THRU HOLES. NEXT MARK EDGE OF DOOR ON
AND SURFACE OF DOOR AT 44" (ADA RECOMMENDED UNLESS
TYPICAL FINISHED
DOOR PREPARATION
FIGURE 3).
MARK THE DOOR AND FRAME.
INSTALLATION
TEMPLATE
FIGURE 1
(SEE FIGURE 2).
FIGURE 2
LATCH BOLT UNIT.
OUTSIDE
IN SWINGING
R.H. DOOR
L
C DOOR EDGE
L.H. DOOR
USE L.H. PUSH/PULL LATCHSET FOR R.H.R. DOORS
USE R.H. PUSH/PULL LATCHSET FOR L.H.R. DOORS
DOOR EDGE
C
L
R.H.R. DOOR
INSTALLATION INSTRUCTIONS
STRIKE
ATTACHING SCREWS
(2) #8 OR 8-32x3/4"
(COMBINATION SCREWS
FOR WOOD OR METAL
FRAMES)
DUST BOX
L.H.R. DOOR
DOOR STOP
HALF DOOR THICKNESS
(MEASURED FROM STOP OR
SILENCER WHEN USED)
CHECK LOCAL ORDINANCE FOR PROPER HEIGHT.
