Luminator LED Trio Light Kit
Model 12.5063MS
General Information:
The Luminator LED Trio Light is equipped with an internal flasher. It comes from the factory in a random flash mode.
Product Specifications:
Optimum Operation Voltage:
+13.8 VDC
Operating Current:
.75 - 1.5 amps
Recommended Fuse:
5 amp
Flash Pattern Selection:
To change flash patterns, momentarily apply +12v to the Yellow "Sync-Mode" Wire for less than 5 seconds.
To reset to factory default pattern, apply +12v to the Yellow "Sync-Mode" Wire for more than 5 seconds.*
Do Not ground YELLOW
When changing flash patterns, you may have to re-start before patterns will sychronize.
Synchronization:
Connect all yellow wires together to synchronize. When wired as shown, the Luminator LED Trio Lights will be
synchronized.
Group Selection:
The White "Group Selection" Wire will determine which lights flash at the same time when you have 2 or more lights.
For Group 1, connect White "Group Selection" wire with Red Power wire.
For Group 2, DO NOT connect White "Group Selection" wire to anything.
Group 1 & Group 2 will alternate.
*Do Not use white wire if using only one light.*
Wiring Instructions:
When wiring, always connect ground wire first and power wire last.
Flash Patterns
1.
Single Flash - 134 FPM
2.
Double Flash - 268 FPM
3.
Quad Flash - 536 FPM
4.
Super Flash - 1070 FPM
5.
Single-On - 134 FPM
6.
Quad-On - 536 FPM
7.
Triple Flash - 401 FPM
8.
Hyper Flash - 1873 FPM
9.
Steady
10.
Random 1-8 (Default)
Wire*
09-10-08
