background image

Insert Battery and Turn On

1

Record A Message

2

Erase A Message

Low Battery Indicator

5

Contact & Warranty Info

Playing A Message

3

Erase A Message

4

Quick Start Guide:  QuickTalker

 S

1.  Remove phillips screw and 

battery door.  

2.  Insert one 9-V battery and  

re-attach battery door and  
phillips screw. 

3.  Slide power switch to on.

1.  Press record button and the visual 

feedback light will turn red. 

2.  Touch the activation area. When 

you hear the auditory beep and 
the visual feedback light starts 
to blink, begin recording your 
message into the microphone.  
Touch the activation area again to 
stop recording. 

3.  Repeat Step 2 for additional 

messages. 

4.   When you are finished recording,  

press the record button again.

1.   To erase a message either record a new message over the existing message or hold the 

record button for three seconds.  You will hear an auditory beep when the message has 
been erased.

1.  Touch the activation area to play message. 

2.   Adjust volume up or down as needed. 

3.   You will see the visual feedback light turn on when the activation surface is touched and 

message plays.

Power ON/OFF

Battery Door

Visual Feedback Light

Microphone

Activation Area

PN 98000034 Rev. B (07/2013)

www.ablenetinc.com

Record Button

Volume

The following are indicators of a low battery and the battery should be replaced.

1.  Immediately after a message plays, the visual feedback light blinks red three times. 

2.   A message begins to play, but stops before completely playing and the visual feedback 

light blinks red three times after the message stops playing.

Summary of Contents for QuickTalker S

Page 1: ...rding press the record button again 1 To erase a message either record a new message over the existing message or hold the record button for three seconds You will hear an auditory beep when the message has been erased 1 Touch the activation area to play message 2 Adjust volume up or down as needed 3 You will see the visual feedback light turn on when the activation surface is touched and message ...

Page 2: ...gelöscht wurde 1 Berühren Sie den Aktivierungsbereich um Ihre Nachricht abzuspielen 2 Stellen Sie die Lautstärke lauter oder leiser wie sie es benötigen 3 Sie sehen dass die Leuchte Visual Feedback leuchtet wenn die Aktivierungsfläche berührt wird und die Nachricht wird abgespielt Hauptschalter EIN AUS Batterieabdeckung Leuchte Visual Feedback Mikrofon Aktivierungsbereich Garantie Reparatur Rückga...

Page 3: ...do audible cuando el mensaje se haya borrado 1 Toque el área de activación para reproducir un mensaje 2 Suba o baje el volumen según sea necesario 3 Verá que la luz de información visual se enciende cuando toca la superficie de activación y el mensaje se reproduce Encendido Apagado Compuerta del compartimento de pilas Luz de información visual Micrófono Área de activación Información sobre la gara...

Page 4: ...n d enregistrement pendant trois secondes Après effacement du message vous entendrez un bip sonore 1 Pour écouter le message enregistré appuyez sur la zone d activation 2 Réglez le niveau du volume en fonction de vos besoins 3 Après avoir appuyé sur la zone d activation le signal visuel lumineux s allume et la lecture du message démarre Marche Arrêt Volet du compartiment de la pile Signal visuel l...

Reviews: