NOTE!!!
TIPS ON CONNECTING YOUR RADIO GEAR AND SOME
ADDITIONAL INFORMATION:
BOARD TOP VIEW
WARNING!!! ALL SETUP PROCEDURES SHOULD BE DONE
WITHOUT
PROPELLERS INSTALLED!!!
RECEIVER CONNECTIONS:
With the connector facing out, the pins are used as follows. Unmarked pin
(left-most top side) is ground, pin marked with dot is 5V supply, the rest are
RC signal pins for CPPM (channel 1) or channels 1 through 8.
Standard female to female servo cable can be used to connect a CPPM receiver. Default channel order is
AIL, ELE, THR, RUD, AUX1..AUX4. A breakout cable is provided for connection to standard receiver.
STANDARD(PCM) RECEIVER:
Connect AIL to 1, ELE to 2, THR to 5, RUD to 6, and AUX1/2 to channels 7 and 8.
FUTABA SBUS RECEIVER
Connect SIGNAL INVERTER (GROUND to G pin, +5v to pin marked «
•
» and SIGNAL to pin 4(bottom row)
