7104 NW 50 Street, Miami, FL 33166 USA • 1-888-993-2228 •
www.AccuBANKER.com
AccuSTAND
Installation Guide for: D470 • LED420 • LED425 • LED430 • LED440
Parts needed
Vertical
surface installation
Horizontal
surface installation
1. Metal stand (1pc)
2. Holding screws (4pcs)
3. Rubber feet (2pcs)
4. Thumb screw * (1-2pcs)
*2pcs needed for D585 model only
5. Guider pole (1pc)
6. Guider knob (1pc)
1. In the location where the detector will be
installed, make two point marks 85 mm
from each other
Fig. 2, hole D
in a horizontal
position to install the holding screws.
2. Tighten the holding screws into the
surface/wall to support the metal base.
3. Proceed to set up the metal base with
the detector as described in the instructions
below (horizontal surface installation).
1. Place the rubber feet into the two holes
labeled
C
in
Fig. 1
2. Screw the Guider pole into the top of the
base in hole
A
indicated in
Fig. 1.
Tighten the
mounting Guider knob into the Guider pole.
3. Insert the Guider pole into hole
E
located at
the base of the detector
Fig. 3
. Attach the
Thumb screw to secure the base of the unit
as shown in
Fig. 4
, using threaded hole
F
indicated in
Fig. 3
.
45°
15°
Fig.
3
Fig.
4
Fig.
2
B
D
C
E
E
F
F
70
85
44.
7
120
15
0
50
A
Fig.
1
