9435 Winnetka Avenue North
Brooklyn Park, MN 55445
www.advance-us.com
Phone 800-850-5559
Fax 800-989-6566
240 Superior Boulevard
Mississauga, Ontario, Canada L5T 2L2
www.nilfisk-advance.ca
Phone 800-668-8400
Fax 800-263-5111
ATTENTION! Do not use the machine before you have read and understood the Instructions for Use Manual.
2. Fill the tank with clean water. The
water temperature must not exceed
40° C.
Make sure the solution valve under
the machine is open.
3. Fill the EcoFlex
™
tank with a
detergent suitable for cleaning
machines (highly concentrated and
low foaming detergent).
4. Install the squeegee and fasten it
with the knob.
External battery charger
1a. Unplug the battery charger cord.
Reconnect it to the machine.
Onboard battery charger
1b. Disconnect the battery charger
cord from the electrical outlet.
18. Clean the machine using a damp
cloth and when needed use a neutral
cleaning product.
16. Press the click-off button and wait
for the brush/pad holder to fall
on the floor. Remove to clean or
change brush.
17. Take the squeegee off and remove
debris. Check and clean the
squeegee blades.
19. Charge the batteries: Connect
the battery charger cord to the
electrical outlet.
20. Park the machine keeping the
recovery tank cover open and
hang the squeegee.
13.
Empty the recovery tank with the
hose. Then empty the solution tank
with the transparent hose.
12.
Machines with EcoFlex: Always turn off
the detergent 2 minutes before finishing
by pressing the detergent button to rinse
out detergent from the system and brush
before handling and cleaning.
10. If necessary press the extra pressure
function (hold for one second).
If necessary press the silent mode
button for extra low sound level.
11. Press the EcoFlex
™
lever whenever
you temporarily need greater
cleaning power.
14. Empty the debris tray and clean/
wash the recovery tank inside.
15. Clean the filter:
A) Close the solu tion valve under the machine.
B) Remove the transparent cover and the gasket,
then remove and clean the filter inside.
C) Reassemble the filter.
7. To engage the brush, press the
brush click-on button.
5. Place the brush or the pad-holder
under the deck. Use the appropriate
brush to clean the floor.
6. Insert the operator key, then start
the machine by pressing the
One-Touch button.
8. Push the drive pedal to start cleaning.
Adjust the speed by applying pressure
to the drive pedal. For the reverse
mode press the yellow lever
.
9. To change the solution flow level
push the solution button and
change the flow level according
to the cleaning performance and
application.
If the machine has been used until the low battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this procedure may cause damage
to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE THE CHARGER IS ALWAYS CONNECTED TO THE BATTERIES EVEN IF NOT USED FOR LONGER PERIOD OF TIME TO PREVENT DAMAGE TO THE BATTERY DUE TO LOW VOLTAGE.
At the end of use
OPERATING GUIDELINES
SC2000
™
