MOUNTING AND MAINTENANCE
INSTRUCTION
LOGIKA 2 AS-OC-OP_IM_ENG - Rev.09 of 16/09/16
Pag. 1 of 3
AS - OC - OP
Made in Italy
Pic. 1
Pic. 2
Pic. 3
Pic. 4
MOUNTING AND MAINTENANCE
The connection system, on pole/bracket or wall
mounting, allows to install the luminaire parallel to
the street.
See related section for particular fixing on pole,
bracket or wall mounting.
To gain access to the electrical parts, unlock and
open the frame [Pic. 1].
The lower frame will open, stopping in vertical
position [Pic. 2].
To connect the luminaire to the electrical line,
insert the cable into the cable clamp and then
connect it to the on-load switch. Tighten the cable
clamp with an adjustable wrench of 25mm applying
a twisting moment of 5Nm.
The feeding of the fitting must be done with a
bipolar cable with nominal diameter between 7 and
13 mm.
When it is necessary, you can take away the gear
tray, loosen the two screws (A-B) and disconnect
the main and lamp connectors (C) [see Pic. 3-4].
To reinsert the gear tray, put it right position and
then tighten the screws and reinsert the connector.
ATTENTION, high voltage danger with RX7
and FC2 lamp holder.
B
C
A
H
Model
Power
Weight [gr]
Empty
With control
gear
70 W
7000
10400
100 W
10500
150 W
11500
250 W
12000
Suggested height of installation
Model
Power [W]
H min [m]
H max [m]
70W
5
10
100W
7
12
150W
7
13
250W
7
14
A
- Ballast
L
- Lamp
f
– Fuse
(500V)
C
- Capacitor
Z
- Ignitor
WIRING SCHEME
SHP - White Son
MHL
WIRING SCHEME
Cosmopolis
Fluorescenti Compatte
L
N
L
Out
A
In
Form factor: 1,2
0.08 m
2
Area exposed to wind
0.21 m
2
ELECTRICAL LINE CONNECTION
< 2 5 mm
6
7 mm
In order to insure double insulation
characteristic of the feeder cable, we
would advise that you first secure the
feeder cable to the internal cable
clamp, remove approximately 25mm of
external sheathing, and 6mm of
sheathing from the internal wires.
This product complies with EU Directive 2002/95/EC.
The crossed-out wastebasket symbol on the appliance
means that at the end of its useful lifespan, the product
must be disposed of separately from ordinary household
wastes. The user is responsible for delivering the appliance
to an appropriate collection facility at the end of its useful
lifespan. Appropriate separate collection to permit
recycling, treatment and environmentally compatible
disposal helps prevent negative impact on the environment
and human health and promotes recycling of the materials
making up the product. For more information on available
collection facilities, contact your local waste collection
service.
INFORMATION TO THE CUSTOMERS
Directive 2002/96/EC (Waste Electrical and
Electronic Equipment - WEEE): information for
users.
