Congratulations on the purchase of your new LAN cable tester. This tester
consists of a main unit and a remote unit. The tester will automatically test
for:
Continuity, Opens, Shorts, Crosses, and Splits.
Auto scanning
enables fast cable testing.
Faults displayed by LED indicators.
Check each pair individually
FEATURES:
Connect the main unit and the remote unit to each end of the cable to
be tested. Press the ON/TEST button on the main unit to turn it unit on.
Press the ON/TEST button again to perform a test. To test pairs
individually, press the FAULT CHECK/TONE button to cycle through the
pairs. To initiate tone sending, press and hold the FAULT
CHECK/TONE button for approximately 5 seconds.
Push the remote unit out from
the main unit.
Connect one end of cable to be
tested to the main unit and the
other to the terminator unit.
Press
"ON/TEST"
twice to
initiate test.
User's Guide
CZ20350
Tone mode can be accessed by pressing the FAULT CHECK/TONE
button for approximately 5 seconds. The tone can be applied to all pairs
or to an individual pair by pressing the FAULT CHECK/TONE button to
cycle through the options.
