Thank you for joining the AeroBed
®
family by purchasing one of our upscale products. You can expect top-notch quality, innovation, and imagination from every AeroBed product.
You are about to enjoy the comfort of an AeroBed. It is your responsibility to read and always follow the safety, care and maintenance instructions for your new AeroBed product.
Always instruct and supervise others on your bed’s proper use, maintenance and safety.
IMPORTANT: Preparation of your AeroBed requires no tools. Use of tools may damage your bed.
7990 Rev 11/07
127 Battery/DC Pump
Flashlight
Instruction Manual
IMPORTANT SAFETY INFORMATION AND WARNINGS
WARNING: Adult supervision required for inflation, deflation, and maintenance. This is not a lifesaving device.
WARNING: This bed is not designed for use by children under 3 years of age. Children under the age of 3 may suffer serious or fatal injury through suffocation, falling from the
bed or becoming trapped between the bed and a wall or other objects.
WARNING: This furnishing has not been evaluated for flammability or cigarette ignition resistance.
- This is not a water toy. Use as a bed only.
- This bed is not intended for infants or persons with limited mobility. They may roll off of the bed and become entrapped between the bed and a wall.
- Do not use this bed on abrasive surfaces or near pointed/sharp items or surfaces. Protruding objects may puncture bed. Remove all sharp objects from area where bed will be
set up and used.
- Do not step or jump on bed or use as a trampoline. Bed may puncture.
- Place bed in a safe area before use, making sure that there are no sharp edges, steps, drops, or breakable items nearby. Use on flat surfaces only.
Bed may tip over on uneven surfaces.
- Standing, jumping, or walking on the bed may result in injury and/or damage the bed. Do not jump, stand, or walk on this bed. You can hurt yourself or damage the bed if you do.
- This bed is made of plastic and therefore may melt or burn if it comes in contact with any flame or heat source. Do not place it near or against heaters, open flame, or other hot
objects.
WARNING: Do not leave the pump plugged into the cigarette lighter or 12-volt DC outlet, doing so could damage the life of the pump motor. PUMP SHOULD ONLY BE USED
WITH ADAPTERS PROVIDED. DO NOT USE WITH ANY OTHER ADAPTERS. To avoid against risk of fire, electric shock or injury to persons, read all instructions before using.
WARNING: Do not operate pump while automotive engine is running.
WARNING: This is an electrical product - not a toy. To avoid risk of fire, burns, injury, or shock, it should not be played with or placed where small children can reach it.
- Unplug adapter when not in use.
- Pump is an electrical device. Do not use in or around water.
- DO NOT place pump where it could fall or be pulled into the water.
- It is recommended to separate batteries from case when pump is not in use.
- Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
- Pump not recommended for use by children under six (6) years of age.
- To avoid eye injury, do not stare directly into beam or shine flashlight into anyone’s face.
- Do not attempt to disassemble, repair, or service the pump. No serviceable parts are contained inside. Contact Aero Products International, Inc.
at 1834 Walden Office Square, Third Floor, Schaumburg, IL 60173, for repair or servicing information.
INFLATION
NOTE: BED MUST BE AT ROOM TEMPERATURE PRIOR TO INFLATING OR IT MAY CAUSE AIR LEAKS.
1. Place your rolled-up bed on the floor or other surface free of obstructions or sharp objects.
2. Remove protective cap on valve by turning cap counter-clockwise. Locate inflation port located at the front of the pump.
3. Press mouth of inflation port into position and turn pump to on position.
4. For BATTERY INFLATION, press the switch up to on position (the symbol “ - ” on the switch means “ON / BATTERY” inflation).
5. For DC ADAPTER INFLATION, press the switch down to on position (the symbol “ = ” on the switch means “ON / DC ADAPTER” inflation).
6. In approximately 60 seconds, your bed will be inflated to the firmest capacity. Press switch to off position (the symbol “ o ” on the switch means “OFF”).
7. Detach pump and replace protective valve cap by turning clockwise.
Bed / Pump
C-CELL BATTERY PUMP WITH DC ADAPTER FOR INSTANT USE
To use pump instantly without having to use C-cell batteries:
a) First, insert the 12-volt DC adapter mini plug into hole.
b) Second, plug the DC power cord into a standard 12-volt DC automobile cigarette lighter or accessory 12-volt outlet and turn ignition to the
accessory portion.
c) When the bed is fully inflated detach pump and unplug the 12-volt adapter from the lighter.
To use pump with C-Cell batteries:
a)
Remove pump from protective plastic shipping wraps.
b) Open battery compartment located at the back of the pump. Pull orange lever up to “open” and pull cap. NOTE: Cap is attached on one side of pump;
Do NOT pull completely off pump.
c) Insert eight new C-cell alkaline batteries (NOT INCLUDED). Make certain the batteries are installed correctly.
d) Replace battery cover by pushing switch down to “close” on back of pump.
BATTERIES MUST BE RECYCLED OR DISPOSED OF PROPERLY.
To use flashlight:
NOTE: Batteries must be installed correctly in order to use flashlight. Flashlight will not work with 12-volt DC adapter.
a) To turn on flashlight, press orange button on top of pump. To turn off flashlight, depress orange button.
b) Flashlight will not work while pump is running through DC adapter.
IMPORTANT: Flashlight contains three energy saving LED bulbs which are NOT replaceable. To prolong life of your flashlight, turn off
when not in use.
Mini Plug
Hole
Inflation
Port
Battery
Compartment (Insert Batteries as Shown)
