INSTALLATION INSTRUCTIONS
MAKE:
Jeep
MODEL:
Wrangler JK
YEAR:
2007-2011
ENGINE:
V6-3.8L
Long Tube Headers & Y-pipe
48-46214-YC (w/Cats)
1: (Read Instructions prior to installation)
Secure vehicle on jack stands (Refer to your
manual for specified jack stand positions).
2:
Disconnect the battery before starting work on the exhaust system.
3:
Remove OE exhaust.
4:
Remove OE Y-Pipe.
5:
Remove the right and left side inner fender splash guards.
6:
Un-Bolt the right and left side down-pipe from the stock manifolds.
7:
Remove the spark plug wires from spark plugs and remove the spark plugs.
8:
Remove the right side exhaust manifold heat-shield.
9:
Remove the right side exhaust manifold (manifold can be removed from under the wheel well).
10:
Remove the right side manifold.
11:
Remove the left exhaust manifold heat-shield.
12:
Remove the left side exhaust manifold be careful not to damage the spark plug wires when
removing the manifold (manifold can be removed from under the wheel well).
13:
Remove the transmission guard-crossmember.
14:
Remove the left side exhaust manifold.
(
Note:
Right and left side aFe headers will be installed from under the vehicle)
15:
Install the right side aFe headers with provided gaskets. Using the stock bolts, tighten starting
with the middle bolt and working your way out. (continue to page 2)
CAUTION:
Allow time for your vehicle to cool down prior to installation. When working on or under your vehicle proceed with caution. Exhaust systems
reach high temperatures and may cause serious burns. Wear protective safety equipment; eye goggles and gloves to ensure a safe installation.
aFe recommends professional installation on our products.
Note: aFe’s Downpipe recommends an aftermarket tuner to clear check engine light
06-86133
Updated: September 2015
Page 1 of 2
Parts Included:
• 2-1/2" SS Band Clamp (x1)
• Ball Joint Clamps (x2)
• 0
2
Extension Leads (x3)
• Zip Ties (x3)
•Heat Sheild (5" x 5")
•Spark Plug Boots (x6)
•Gaskets, Header (x2)
•Spacer (x2)
•Spacer (x1)
