Installation Instructions
450-756
850-344 Airaid Oiled Media Filter
451-756
851-344 SynthaMax Dry Media Filter - Red
Component Identification
2018 FORD Mustang GT
V8-5.0L
For Part Numbers:
Full color instructions can be viewed on our web site at Airaid.com. If you need any assistance please call 1-800-498-6951 to speak with
a representative in our Customer Service Center before returning the product.
See Airaid.com for CARB status on each part for a specific vehicle
NOT LEGAL FOR SALE OR USE ON ANY POLLUTION
CONTROLLED MOTOR VEHICLE IN CALIFORNIA OR
STATES ADOPTING CALIFORNIA EMISSION PROCEDURES.
1. Turn off the ignition and disconnect the negative
battery cable.
NOTE: Disconnecting the negative battery cable
erases pre-programmed electronic memories. Write
down all memory settings before disconnecting the
negative battery cable. Some radios will require
an anti-theft code to be entered after the battery is
reconnected. The anti-theft code is typically supplied
with your owner’s manual. In the event your vehicles
anti-theft code cannot be recovered, contact an
authorized dealership to obtain your vehicles anti-
theft code.
TO START:
Description
Qty. Part #
A
B
C
D
E
F
G
H
I
J
FACTORY
PART
FACTORY
PART
K
L
A
A
HOSE CLAMP #56
2
08620
B
HOSE; HUMP 3.5"ID X 2.5"L
1
KITCOUPLER09
C
VENT FITTING 3/8”
1
82631
D
GROMMET 3/8” ID
1
08100
E
INTAKE TUBE
1
KIT756A
F
GROMMET 1/2” ID
1
08064
G
VENT FITTING 1/2”
1
82629
H
HOSE CLAMP #60 STAINLESS
1
08628
I
HOSE; HUMP 4"ID X 3"L
1
KITHUMPHS48
J
HOSE CLAMP #64 STAINLESS
1
08645
K
AIR FILTER
1
850/851-344
L
CAPLUG
1
08246
2. Remove the four nuts that secure the strut brace and
then remove the strut brace from the vehicle. Pop up the
two-round bolt covers.
3. Remove the two nuts that secure the decorative engine
cover and remove the cover from the engine.
4. Release the spring clamp that secures the sound tube
to the intake tube fitting and then disconnect the sound
tube from the intake tube. Disconnect the quick connect
vent lines shown.
6. Release the one-time use clamp that secures the sound
tube to the drum and then disconnect and remove the
sound tube from the vehicle.
5. Loosen the hose clamps that secure the intake tube to
the air filter housing and throttle body and then remove
the intake tube from the vehicle.
NOTE: AIRAID recommends that customers do not
discard factory air intake.
