background image

HOBO® Temp/RH 3.5% Data Logger (UX100-003) Manual 

The HOBO Temp/RH data logger records temperature and relative humidity (within 3.5% 
accuracy) in indoor environments with its integrated sensors. Using HOBOware®, you can easily 
configure the logger alarm to trip for specific high or low sensor readings. Or, you can set up burst 
logging in which the logger records data at a different interval during certain conditions. The 
logger can also calculate minimum, maximum, average, and standard deviation statistics. This 
compact data logger has a built-in LCD screen to monitor the current temperature, relative 
humidity, logging status, battery use, and memory consumption in between readouts.  

Specifications 

Temperature Sensor 

 

Range 

-20° to 70°C (-4° to 158°F) 

Accuracy 

±0.21°C from 0° to 50°C (±0.38°F from 32° to 122°F), see Plot A 

Resolution 

0.024°C at 25°C (0.04°F at 77°F), see Plot A 

Response Time 

4 minutes in air moving 1 m/s (2.2 mph) 

Drift 

<0.1°C (0.18°F) per year 

RH Sensor 

 

Range 

15% to 95% (non-condensing) 

Accuracy 

±3.5% from 25% to 85% including hysteresis at 25°C (77°F); below 
25% and above 85% ±5% typical 

Resolution 

0.07% at 25°C (77°F) and 30% RH 

Response Time 

43 seconds to 90% in airflow of 1 m/s (2.2 mph) 

Drift 

<1% per year typical 

Logger 

 

Logger Operating Range 

Logging: -20° to 70°C (-4° to 158°F); 0 to 95% RH (non-condensing) 
Launch/Readout: 0° to 50°C (32° to 122°F) per USB specification 

Logging Rate 

1 second to 18 hours, 12 minutes, 15 seconds 

Logging Modes 

Fixed interval (normal), burst, or statistics 

Memory Modes 

Wrap when full or stop when full 

Start Modes 

Immediate, push button, date & time, or next interval 

Stop Modes 

When memory full, push button, or date & time 

Restart Mode 

Push button 

Time Accuracy 

±1 minute per month at 25°C (77°F), see Plot B 

Power Source 

One 3V CR2032 lithium battery and USB cable 

Battery Life 

1 year, typical with logging rate of 1 minute and sampling interval of 
15 seconds or greater 

Memory 

128 KB (84,650 measurements, maximum) 

Download Type 

USB 2.0 interface 

Full Memory Download Time 

20 seconds 

LCD 

LCD is visible from 0° to 50°C (32° to 122°F); the LCD may react slowly 
or go blank in temperatures outside this range 

Size 

3.66 x 8.48 x 1.52 cm (1.44 x 3.34 x 0.6 in.) 

Weight 

30 g (1.06 oz) 

Environmental Rating 

IP50 

 

The CE Marking identifies this product as complying with all relevant 
directives in the European Union (EU). 

 

HOBO Temp/RH 3.5% 
Data Logger 

UX100-003 

Included Items: 

 

Command™ strip 

 

Double-sided tape 

 

Hook & loop strap 

Required Items: 

 

HOBOware 3.4 or later 
(download at 
www.onsetcomp.com/ 
hoboware-free-download) 

 

USB cable 

 

 

 

 

 

 

Office: Jl. Radin Inten II No. 62 Duren Sawit, Jakarta 13440 - Indonesia
Workshop: Jl. Pahlawan Revolusi No. 22B, Jakarta 13430 - Indonesia
Phone: 021-8690 6777 (Hunting)

Fax: 021-8690 6777

Mobile: +62 816 1740 8925

Fax: 021-8690 6771

Summary of Contents for Hobo UX100-003









Reviews: