Lark
Board
is
a
high-performance
development board based on Altera’s
Cyclone® V SoC, designed for development
of high-volume applications including
automotive, medical equipment, video
surveillance and industrial control. The Lark
Board features a 5CSXFC6D6 SoC FPGA, the
largest SoC device in the Cyclone V SX
family and provides 1GB DDR3 SDRAM to
each of the HPS and FPGA as well as 4GB
eMMC Flash and a Transflash card slot for
mass storage. It also features several
standard I/O interfaces including PCI
Express, Gigabit Ethernet, HDMI, VGA, 24-
bit LCD, a 12-bit camera interface, USB2.0 Host ports, UART, JTAG, and 3G SDI. It also integrates
a 12-bit high-speed and high-accuracy ADC with sampling rate up to 105MSPS.
Kit Contents
1 x Lark Board
1 x USB cable for FPGA programming and control
1 x 19V AC/DC power adapter and power supply cable
Universal Power Plug Adapter
8GB preloaded TF card which contains:- A pre-built Debian image, source code,
schematics and datasheets
12V-DC Fan
Setting Up the System
Set the DIP Switches
The Lark board eMMC Flash has been installed with Yocto image by
default so that the board can boot and run out of the box. Please check
the DIP switches are configured as shown in the table below.
Switch
D1
D2
D3
D4
S8
Off
On
Off
Off
S9
Off
Off
On
Off
S10
Off
Off
Off
Off
S11
Off
Off
On
Off
Key Information Sheet - Lark Board
