P e r f e c t R a d i a t o r
Meltem
DIRECTIONS FOR MOUNTING AND USE
Figure 1
Figure 2
1. Left Bracket
2. Right Bracket
3. Clapper
4. Intermediate Supporting Element
e. Clapper Latch
f. Clapper Plastic Pin
The installation connections of Alurad Meltem
Radiators which are made of aluminum are made
in the same way as for other hot-water radiators.
Different from other radiators, however, Alurad
allows the making of " lower opposite end "
connection. Mount the radiator without removing
it from its nylon packing. Remove the protective
nylon cover by cutting it before use, after
completion of all alteration and painting works.
The initial putting of the radiator into operation may
be carried out while the nylon cover is on.
Alurad Meltem Radiators can be easily mounted
on the wall using the brackets (Figure 1).
The radiator valve connection is 1/2. Either
chromium or nickel plated radiator valves should
be used. All elements required for mounting are
included in the packing. The top side of the
radiator is the side with the profile shown in Figure 2.
Mounting Operation
If the installation branches are installed, check the
position of connection of the radiator. In doing this,
pay attention to the masurements given (Figure 3
and Figure 3 a). Place the plastic plugs into their
places before making the coupling connections,
and then make the required connections according
to the style of branching.
Mount the left bracket (Figure 1, No 1) onto the wall
using the holes bored with a drill, and a screwdriver.
(Take care that the bracket is positioned vertically.)
After passing the plastic pin of lower clapper
(Figure 1, No f) trough the circular hole provided
at the bottom of the bracket, fit the joining pin.
By taking into consideration the measurements
given in Figure 3 and Figure 3 a, determine the
location of right bracket. Fit the clapper latch onto
the right clapper by passing it through the circular
hole provided at the bottom, and then fit its joining
pin (Figure 1, No. e). The lenght of the clapper will
also allow you to check whether or not the location
of bracket holes and your measurements for
mounting the right bracket are correct.
After mounting the right bracket loosely in its place
too, move the clapper by means of the clapper latch
(Figure 4). When you are sure that it moves freely,
fix the right bracket securely by tightening its screws
firmly.
Screw Center Distance (mm)=
(40 x Number of Radiator Columns) – 65mm
(Figure 3)
