Outboard Racing Starting Clock
User Manual
Introduction:
Outboard Racing Starting Clock –
Use for Countdown to Begin Boat
Race
•
3-Digit Main Display (DSP3603A) with 36” High
Digits
•
Controller (DS204A-BSC) Capable of Count
Down Timing between 5 Minutes and 0
•
Unistrut Stand (SUPERSTRUTB-1400-HS)
•
Race Clock Cover
•
Go online for video tutorials -
Components:
Controller (DS204A-BSC)
•
4-Digit Display with 2.5” High Digits
•
6 Waterproof Buttons in Water Resistant
Enclosure
•
One Connector for Connecting to Right Digit of
Main Display: 30' 4 -Conductor 18GA Cable
Power Specifications
•
Display Input Voltage Range: 12-14.5 Volts DC
•
Display Powered by 12 Volt Car Battery
•
Display Alternate Power Source: 15 AMP or
Larger Power Supply may be used
•
Current consumption:
•
All Segments ON: 12 AMP
•
All Segments OFF: 1/2 AMP
Cables
•
Left Digit to Center Digit: 40” 7-Conductor 14GA
Cable
•
Center Digit to Right Digit: 40” 7-Conductor
14GA Cable
•
Right Digit to Power Source: 15” 4-Conductor
14GA Cable
•
If you have an optional second display, a 10' 4-
Main Display (DSP3603A)
•
Overall Display Size 48” High x 96” Wide
•
3-Digit Display showing M:SS (min & sec)
•
Digits 36” High x 21” Wide
•
Red LED Solid Segment Digits
•
Digits Each in Separate Enclosures
•
Enclosure Each 48” High x 32” Wide
•
Enclosure Covered with 1/8” Thick
Transparent Red Plexiglas (#2423)
•
Left Digit
•
LED Clusters to Represent Colon
between Min and Sec in Mode 0 & 1
•
Chassis Mount Connector x 1 for Power
and Data from Center Digit
•
Center Digit
•
LED Cluster to Represent Decimal
between Sec and Tenths in Mode 1
•
Chassis Mount Connector x 2, 1 for
Power and Data, 1 to Pass Power and
Data to Left Digit
•
Right Digit
•
Chassis Mount Connector x 4, 3 Supply
Power and Data for all 3 Digits (see
Wiring Diagram for Connection Details), 1
for Camera LED
1
Alzatex, Inc.
