background image

Made in China

C001-CA-V1.0

17

INSTRUCTION BOOKLET

WARNING: Never leave product charging unattended for extended periods of

time. Always disconnect the battery from charger immediately after the battery

is fully charged. Please refer to enclosed safety instructions.

PACKAGE CONTAINS:

Colors and styles may vary slightly .

Instruction 

Manual

Spare Parts

Battery

PA-1003

USB Charger 

2.4G Wireless

 Controller

ON BOARD

HD VIDEO

ON BOARD

HD CAMERA

1280 x 720 pixel 
25 frames per second

Phone Holder

CHOKING HAZARD - Small parts. 
Not suitable for children under 3 years.

WARNING!

HD STREAMING VIDEO DRONE

PA-1003

FCC RF exposure statements

This Transmitter must not be co

located or operating in conjunction with any other antenna or transmitter.

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This 
equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator 
and  your body or nearby persons.

IC Radiation Exposure Statement:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment 

should be installed and operated with minimum distance 20cm between the radiator & your body.

Conforms to safety requirements of FCC.

Voyage Aeronuatics™  is the registered trademark of AMAX Industrial Group LTD. 
AMAX Group USA Address: 12645 Memorial Dr Suite F1 #388 Houston, TX 77024 
© 2020 All Rights Reserved. Visit us at www.amaxbrands.com

Requires Speed Class 6 or higher microSD or
microSDHC card(not included)

microSDHC Logo is a trademark of SD-3C, LLC.

FCC Part 15 C Notice

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could 
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful interference to radio or television reception, 
which can be determined by turning the equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures:

฀฀฀฀

฀ ฀

฀฀฀฀

฀฀฀฀

฀ ฀

฀ ฀ ฀

฀ ฀

฀ ฀

      connected.

฀฀฀฀

฀ ฀

฀ ฀

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : 
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired 
operation.

Summary of Contents for PA-1003










Reviews: