Activate your account and device
AMERICALOC ST4340
Go to
www.americaloc.com
, select
United States and click the
Activate Now button.
Before using our products or installing a device, carefully read our legal terms which you can find at
https://us.americaloc.com/legal_info.html
Fill in the required information. The IMEI
code can be found below the bar code
that is printed on the back of your device.
Your account will now be ready to use.
Go to
www.americaloc.com
and
log in with the username and
password established in the
previous step.
Purchase one of our service plans by
clicking on the
Click to pay service
button.
A window will open to provide you with
payment instructions.
Turn OFF and then ON the device after initial service payment.
Your device already comes
with a SIM card installed.
Please do not remove the SIM card
.
1
3
2
4
5
Appearance and LED behavior
Welcome to AMERICALOC
IMPORTANT:
Your complete satisfaction is our first priority! If you have a problem or need assistance
please contact us at
support@americaloc.com
. Rest assured we will find a solution for you. Our friendly,
knowledgeable customer service representatives are standing by to explain our services and to assist
you in getting the most from your GPS tracking service.
If you plan to use the unit outside of the U.S. please contact Americaloc support so we can configure
your unit or provide a different SIM card if needed.
If you do not wire the ignition cable please contact support so we can configure your unit to detect
ignition by motion.
LED
Device Status
Blink Count
(Fast continuous flashing)
CEL
(blue)
GPS
(red)
Connected
Server Communication Error
LTE-M1 Communication Error
No network
SIM PIN Locked
Can not attach to Network
No SIM
Connected
GPS chip is searching GPS info
GPS Chipset Error or
GPS Antenna Error
1
2
3
4
5
6
7
1
2
4
The blue wire is used for ignition detection. It is strongly recommended to connect this wire to ignition
key at “RUN” position as shown above.
An alternative to connecting to the ignition switch is to find a non-permanent power source (like the
power source for FM radio) that is only available when the vehicle is running. Ignition signal can be
configured to start transmitting information to the backend server when ignition is on and to enter
power saving mode when ignition is off.
GROUND
IGNITION
Ignition Positions
1
) Off
2 ) Accesories
3 ) Run (Use this one)
4 ) Start
1
2
3
4
Best place: Under front dashboard
Device Vin
-
8 V-32V
PINOUT
1. Vin, Red
2. GND, Black
3.
IGN, Blue
ST4340
st
nd
rd
th
st
nd
rd
th
Installation Diagram ST4340
Note:
Cables that are not used in this installation must be individually cut and covered with black/electrical
tape to avoid short circuit.
Recommendation:
Professional installation is recommended. Stereo and car alarm installers
usually know how to install these devices.
