background image

J33

BARRIER FREE

© 2008 AS America Inc.

FINISHED

WALL

OR 

SPLASH BACK

COUNTERTOP
CUTOUT 324mm
(12-3/4) DIA.

175mm

(6-7/8)

349mm

(13-3/4)

38mm

(1-1/2)

MIN.

51mm

(2)

MIN.

B

A

C/L

1-1/4 O.D.

TAILPIECE

1-1/4 O.D.

WASTE

203mm

(8)

168mm

(6-5/8)

178mm

(7)

16mm

(5/8)

COUNTERTOP

(BY OTHERS)

SEALING

COMPOUND

SUPPLIES

AS REQ'D.

305mm

(12)

*

254mm

(10)

*

FINISHED

FLOOR

787mm

(31)

SUGGESTED

848mm

(33-3/8)

FITTING

CENTER-SET

SPREAD

A

27mm(1-1/16)

32mm(1-1/4)

B

102mm(4)
203mm(8)

848mm

(33-3/8)

51mm

(2)

610mm

(24)

152mm

(6)

MAX.

BARRIER FREE

CLEARANCE

686mm

(27)

MIN.

203mm

(8)

MIN.

229mm

(9)

MIN.

DRAWING FOR 

DIMENSIONAL 

PURPOSES ONLY. 

IT IS NOT AN EXACT 

REPRESENTATION.

ROYTON™

COUNTERTOP SINK

VITREOUS CHINA

ROYTON™ COUNTERTOP SINK

•  Made from vitreous china
•  Self-rimming with cutout template supplied
•  Center drain outlet
•  Front overflow

 

0571.000

 Round sink without faucet deck

 

Nominal Dimensions: 

 

349mm (13-3/4") Round

Bowl size:

273mm (10-3/4") round
140mm (5-1/2") deep

Compliance Certifications -
Meets or Exceeds the 
Following Specifications:

• ASME A112.19.2M for 
  Vitreous China Fixtures

To Be Specified:

  Color: 

  White   

  Bone 

               

  Linen   

  Silver   

                

  Fawn Beige    

  Black

  Faucet*:

  Faucet Finish:

❏ 

Supplies:

  1-1/4" Trap:

* See faucet section for additional models available

MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES
AND ANSI A117.1  ACCESSIBLE AND USABLE
BUILDINGS AND FACILITIES - CHECK LOCAL CODES.

Install lavatory 864mm (34") from finished floor.
Lavatory installed 51mm (2") minimum from front edge
of countertop provides 686mm (27") knee clearance area.  

NOTES:

DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP 

ARE SUGGESTED.

FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE 

TEMPLATE SUPPLIED WITH SINK.

FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED 

SEPARATELY.

SEALING COMPOUND SUPPLIED BY OTHERS.

IMPORTANT:

  Dimensions of fixtures are nominal and may vary within the 

range of tolerances established by ANSI Standard A112.19.2.

These measurements are subject to change or cancellation. No responsibility 

is assumed for use of superseded or voided pages.

Revised 2/08

Reviews: