background image

©Copyright Amkus Rescue Systems, Inc. 2010-2020 

LAP-005 JUNE 22, 2020 Rev05

Serial Number

_______________________

Thank you for choosing AMKUS Rescue Systems.  Please read this User Information Manual 

thoroughly.  If you have any questions, please contact your local dealer or AMKUS, Inc.
Please complete the tool registration form included with your equipment and return it to AMKUS, Inc.  

You may also register your equipment on-line at www.amkus.com.  
The serial number for your power unit is identified on the product label which is located on the yellow 

hydraulic fluid reservoir.  For quick reference, record the serial number on the cover of this manual.  

Please have the serial number available if you need to contact your local dealer or AMKUS, Inc.

 

EN13204 Designation:  MTO

DECLARED DUAL-NUMBER NOISE EMISSION VALUES

 

in accordance with EN ISO 4871

Measured A-weighted emission sound pressure level, L

pA

 (ref. 20µPa), in decibels: 88.2

Uncertainty, K

pA

, in decibels: 1.5

Measured A-weighted sound power level, L

WA

 (ref. 1 pW), in decibels: 100.2

Uncertainty, K

WA

, in decibels: 1.5

Values determined according to Annex B of EN 13204 using the basic standards

EN ISO 3744 and EN ISO 11201.
Note: The sum of a measured noise emission value and its associated uncertainty represents an 

upper bound of the range of values which can occur in measurements.

AMKUS RESCUE SYSTEMS

amkus.com

4201 Montdale Drive, Valparaiso, IN 46383-4098 USA

800-592-6587 • 219-548-5000 • Fax 219-476-1669

Manual: 

GB2S-XLO Power Unit

Do not use this product until you have read this manual and understand all 

safety and operating instructions!  Failure to comply with these warnings and 

instructions may result in serious injury, disease, illness or death.

WARNING

Summary of Contents for GB2S-XLO

Page 1: ...Designation MTO DECLARED DUAL NUMBER NOISE EMISSION VALUES in accordance with EN ISO 4871 Measured A weighted emission sound pressure level LpA ref 20µPa in decibels 88 2 Uncertainty KpA in decibels 1 5 Measured A weighted sound power level LWA ref 1 pW in decibels 100 2 Uncertainty KWA in decibels 1 5 Values determined according to Annex B of EN 13204 using the basic standards EN ISO 3744 and EN ...

Page 2: ...l and hydraulic fluid levels Add as appropriate Read and understand the engine owner s manual before operating the engine Failure to do so could result in personal injury or equipment damage Set Up Procedures Normally AMKUS equipment is prepared and serviced by your dealer prior to delivery If however you have decided to place the equipment into service yourself please review the following instruc...

Page 3: ... coupling Move the selector valve to charge the line to which the gauge is connected The nominal pressure of the system is 10 500 psi The pressure reading you receive should be between 10 000 psi and 11 000 psi If you have a reading outside of that range contact your local dealer or AMKUS Inc DO NOT ATTEMPT TO ADJUST THE PRESSURE RELIEF SETTING Routine Maintenance for Hoses After each use hoses sh...

Page 4: ... while the couplings may be clean the dust caps will accumulate dirt during use Do not cover a clean coupling with a dirty dust cap GB2S XLO Power Unit Specifications Length 23 0 in 584 mm Width with one hose loop standard 19 0 in 483 mm Height 20 5 in 521 mm Weight Ready to use 109 6 lbs 50 kg Includes gas engine oil hydraulic fluid and couplings Rated Output Pressure 10 500 psi 724 bar Fluid Typ...

Reviews: