READ CAREFULLY THE PRODUCT
INSTALLATION, OPERATING AND
MAINTENANCE MANUAL. FAILURE TO FOLLOW THE
INSTRUCTIONS AND WARNINGS IN THE MANUAL MAY
RESULT IN SERIOUS OR FATAL INJURY AND/OR PROPERTY
DAMAGE, AND WILL VOID THE PRODUCT WARRANTY.
THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED
PROFESSIONAL. FOLLOW ALL APPLICABLE LOCAL AND
STATE CODES AND REGULATIONS, IN THE ABSENCE OF
SUCH CODES, FOLLOW THE CURRENT EDITIONS OF THE
NATIONAL PLUMBING CODE AND NATIONAL ELECTRIC
CODE, AS APPLICABLE.
This product must be installed by a qualified
professional.
EXPLOSION HAZARD.
Failure to follow the
instructions in the accompanying product
manual can cause a rupture or explosion; possibly causing
serious or fatal injury, leaking or flooding and/or property damage.
Use only with potable water system. Do not
operate in a setting with freezing temperatures
or where the temperature can exceed 200°F and do not exceed
the maximum working pressure specified for this Product in the
Manual. Mount vertically only.
This Product, like most Products under
pressure, may over time corrode. weaken and
burst or explode, causing serious or fatal injury, leaking or
flooding and/or property damage. To minimize risk, a licensed
professional must install and periodically inspect and service the
Product. A drip pan connected to an adequate drain must be
installed if leaking or flooding could cause property damage. Do
not locate in an area where leakage of the tank or connections
could cause property damage to the area adjacent to the
appliance or to lower floors of the structure.
Chlorine & Aggressive Water:
The water
quality can significantly influence the life of this
Product. You should test for corrosive elements, acidity, total
solids and other relevant contaminants, including chlorine and
treat your water appropriately to insure satisfactory performance
and prevent premature failure.
CALIFORNIA PROPOSITION 65 WARNING:
This product contains a chemical known by the
State of California to cause cancer and to cause birth defects or
other reproductive harm. (California Installer/Contractor -
California law requires that this notice be given to consumer/end
user of this product.) For more information: www.amtrol.com/
prop65/htm.
THIS IS THE SAFETY ALERT SYMBOL. IT IS
USED TO ALERT YOU TO POTENTIAL PERSONAL
INJURY AND OTHER HAZARDS. OBEY ALL
SAFETY MESSAGES THAT FOLLOW THIS SYMBOL
TO REDUCE THE RISK OF PERSONAL INJURY AS WELL AS
PROPERTY DAMAGE.
EXPLOSION OR RUPTURE HAZARD
A relief
valve must be installed to prevent pressure in
excess of local code requirement or maximum working pressure
designated in the Product Manual, whichever is less. Do not
expose Product to freezing temperatures or temperatures in
excess of 200° F. Do not adjust the pre-charge or re-pressure
this Product except for any adjustments required at the time of
initial installation, especially if Product corroded, damaged or with
diminished integrity. Adjustments to pre-charge must be done at
ambient temperature only. Failure to properly size the Product or
follow these instructions may result in excessive strain on the
system and lead to Product failure, serious or fatal personal
injury, leakage and/or property damage.
NOTE:
Inspect for shipping damage and notify freight carrier or
store where purchased immediately if damage is present. To
avoid risk of personal injury and property damage, if the product
appears to be malfunctioning or shows signs of corrosion, call a
qualified professional immediately. Current copies of the Product
manual can be viewed at www.amtrol.com. Use proper safety
equipment when installing.
FAILURE TO PROPERLY SEAL WILL
RESULT IN LOSS OF PRECHARGE
CAUSING PRODUCT TO FAIL.
GENERAL SAFETY INFORMATION -
ADDITIONAL SPECIFIC SAFETY
ALERTS APPEAR IN THE FOLLOWING INSTRUCTIONS.
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
MARK OF THE ORIGINATOR
* All ST-C Series models come with a 1 year warranty. See reverse side for warranty information.
1400 Division Road, West Warwick, RI 02893 T: 401.884.6300 F: 401.885.2567 www.amtrol.com
INSTALLATION, OPERATION & SERVICE INSTRUCTIONS
THERM-X-TROL
®
THERMAL EXPANSION ABSOBERS (ST-5-C THROUGH ST-210V-C)
Part #: 9017-091 (04/11)
