background image

SV

SV7-IP Quick Setup Guide

Requirements

 

A compatible servo motor.

 

A small flat blade screwdriver for tightening the connectors (included).

 

A personal computer running Microsoft Windows 98, NT, Me, 2000, XP, Vista, or 7.

 

Quick Tuner™

 software (version 2.2.17 or later) available at www.applied-motion.com/products/software.

 

A CAT5 network cable (not included).

 

For more detailed information, please download and read the 

SV7 Hardware Manual

, available at www.applied-motion.com/support/manuals.

To begin, make sure you have the following equipment:

Step 1

a) 

 Download and install the 

QuickTuner™ 

 software.

b) 

 Launch the software by clicking:  

 

 

 Start / Programs / Applied Motion Products / Quick Tuner

c) 

 Connect the drive to your network or PC using a standard CAT5 cable.

d) 

 Select an appropriate IP address using the rotary switch on the SV7-IP. For more information 

about network configurations and IP addressing, please consult the 

SV7 Hardware Manual.

Step 2

 Wire the drive to the DC power source.

 

 

(Do not apply power until all connections to 

the drive have been made)

 

 

 

Note, the SV7 drives accept DC power from 

24-80 VDC.
For a non-Applied Motion Products motor, please 

refer to your motor specs for wiring information.

Be sure to connect the motor case ground to the 

grounding screw as indicated, leaving the last 

pin on the motor/power connector unconnected.

4

3

21

0 F E D C B A 9

87

6

5

V+

V-

Motor A (or U) phase

Motor B (or V) phase

Motor C (or W) phase

Motor

Grounding

Screw

a) 

 Connect the I/O

b) 

 Connect the Encoder

 

Applied Motion motor cables 

are available with connectors 
that mate directly to the 
encoder connector on the drive.

Step 4

encoder Z+ (5) 

Hall 1-(10) 

encoder B- (4) 

Hall 1+ (9) 

encoder B+ (3) 

Hall 3+ (13) 

Hall 3- (14) 

GND (15)

(12) Hall 2- 

(11) Hall 2+ 

(6) encoder Z- 

(1) encoder A+ 

(7) +5VDC 200mA 

(2) encoder A- 

(8) GND 

Front View

ENCODER 

Front View 

X COMMON 

not used

X3 /  Enable 

X5 / CWJOG 

X4 / Alarm Reset 

Analog IN2 

Analog IN1 

X2 / DIR- 

X2 / DIR+ 

X1 / STEP + 

X1 / STEP - 

GND 

GND 

+5V OUT  

Y COMMON 

Y3 / FAULT 

Y2 / MOTION 

Y1 / BRAKE 

1 8

1 7

1 6

1 5

1 4

1 3

1 2

1 1

1 0

9

8

7

6

5

4

2

3

1

1 9

2 0

2 1

2 2

2 3

2 4

2 5

X6 / CCWJOG  

IN/OUT 

X8/C  

X8/CCWLIMIT- 

X7/CWLIMIT- 

X7/ 

Y4- 

Y4+ 

920-0053 rev A

Reviews: