INSTALLATION
➊
Place the Edge LED Fixture on the aquarium
so the aquarium frame mounts are holding
the fixture above the glass covering over the aquarium.
➋
When the aquarium frame mounts are adjusted to hold
the fixture securely on the aquarium frame, tighten the
locking screws to prevent the aquarium frame mounts
from moving positions.
➌
Connect the power supply.
➍
Program the three channel digital timer.
PARTS LIST
Light Fixture
Aquarium Frame Mounts
Power Supply
Instruction Guide
w w w . a q u a t i c l i f e . c o m
Edge LED Instruction Guide
A)
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
B)
DANGER
– To avoid possible electric shock, special care should be taken since water is employed
in the use of aquarium equipment. For each of the following situations, do not attempt repairs by
yourself; return the appliance to an authorized service facility for service or discard the appliance:
1) If the appliance falls into the water, DON’T reach for it! First unplug it and then retrieve it.
If electrical components of the appliance get wet, unplug the appliance immediately.
(Non-immersible equipment only)
2) If the appliance shows any sign of abnormal water leakage, immediately unplug it from
the power source. (Immersible equipment only)
3) Carefully examine the appliance after installation. It should not be plugged in if there is
water on parts not intended to be wet.
4) Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning
or has been dropped or damaged in any manner.
5) To avoid the possibility of the appliance plug or receptacle getting wet, position aquarium
stand and tank to one side of a wall-mounted receptacle to prevent water from dripping
onto the receptacle or plug. A “drip loop," shown in the figure below, should be arranged by
the user for each cord connecting an aquarium appliance to a receptacle. The “drip loop" is
that part of the cord below the level of the receptacle, or the connector if an extension cord
is used, to prevent water traveling along the cord and coming in contact with the receptacle.
If the plug or receptacle does get wet, DON’T unplug the cord. Disconnect the fuse or circuit
breaker that supplies power to the appliance. Then, unplug and examine for presence of
water in the receptacle.
C) Close supervision is necessary when any appliance is used by or near children.
D) To avoid injury, do not contact moving parts or hot parts such as heaters, reflectors,
lamp bulbs, and the like.
E) Always unplug an appliance from an outlet when not in use, before putting on or taking off parts,
and before cleaning. Never yank the cord to pull the plug from outlet. Grasp the plug and pull
to disconnect.
F) Do not use an appliance for other than intended use. The use of attachments not recommended
or sold by the appliance manufacturer may cause an unsafe condition.
G) Do not install or store the appliance where it will be exposed to the weather or to temperatures
below freezing.
H) Make sure an appliance mounted on a tank is securely installed before operating it.
I) Read and observe all the important notices on the appliance.
J) If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less
amperes or watts than the appliance rating may overheat. Care should be taken to arrange the
cord so that it will not be tripped over or pulled.
K) For added safety, the appliance must be plugged into a receptacle controlled by a GFCI
(ground fault interrupter) circuit breaker. The device must be properly connected to a
grounded three-prong receptacle.
L) This appliance is intended FOR HOUSEHOLD USE ONLY.
M) This Light Fixture is required to be used over a covered aquarium. A glass top or protective barrier
is required to minimize the fixture's exposure to water.
N)
SAVE THESE INSTRUCTIONS.
WARNING
TO GUARD AGAINST INJURY,
BASIC PRECAUTIONS SHOULD BE
OBSERVED INCLUDING ALL
INSTRUCTIONS IN THIS MANUAL.