background image

User's manual

Recessed carriageable LED inground ­ 1 out

This  unit  should  only  be  used  for  purpose  for 
which  it  has  been  intended  and  should  be 
installed  using  the  instructions  which  are 

provided.  Arena  Luci  cannot  be  held  liable  for 
damages  to  person,  animals  or  objects  as  a 
result  of  improper,  unreasonable  and  wrong 
usage.

This  instruction  manual  contains  important 
information  about  the  installation  and  use  of  the 
projector.  Please  read  and  follow  these 
instructions carefully.

The  security  of  this  device  is  guaranteed  only 
with  the  proper  use  of  the  following  instructions, 
therefore they must be kept carefully.
Never  install  the  device  in  locations  easily 

accessible by people who ignore the existence of 
this user's manual and safety instructions.
For  the  wiring  please  refer  to  enclosed  wiring 
diagrams.  If  in  the  diagrams  indicated  there 

should not be that of your application, contact the 
technical office.
Disconnect the unit from any power supply before 
attempting  any  operation  in  contact  or  inside  the 

unit, and when not in use.
It  is  essential  that  electrical  installation  conforms 
to all relevant standards.
Prior  to  connect  the  unit  to  the  power  supply, 

check  the  output  voltage  fits  the  technical 
requirements on the label.
Never  let  the  power  cord  come  into  contact  with 
other cables.

Never touch the electrical contacts, either directly 

with your fingers, or indirectly by means of sharp 
or metal objects.
Make sure that cables cannot cause trip hazard.

Do not attempt to dismantle and modify the unit.
Due  to  the  high  technological  level  of  this  unit, 
any service maintenance should be performed by 
specialised operators. Please contact your Arena 

Luci dealer for any operation.
When  assembling  make  sure  that  the  cable 
glands are tightened for a watertight seal.
Avoid installing the unit close to heat sources.

Never lean the power cord on hot unit surfaces.
Allowed  to  be  mounted  directly  on  inflammable 
surfaces.
LED module is not replaceable.

Do  not  use  any  solvent  based  cleaning  agents. 
Use only a soft, dry anti­static cloth.
The installation of LED modules (including power 
supplies)  should  be  done  according  to  current 

technical  rules  and  regulations.  The  installation 
should be performed only by a qualified operator.
This luminaire is an outdoor IP67 device, but not 
IP68  (underwater).  Therefore  the  proper  and 

extended functioning will be related to the proper 
installation.
To  avoid  infiltrations  inside  the  inground  box  do 
not  open  or  install  this  luminaire  during  rainy 

days or in high humidity conditions.
Avoid  contact  with  either  corrosive  agents  or 
humidity  and  moisture  on  delicate  elements: 
damages  from  corrosion  are  not  refunded  as 

component defects.

WARNINGS

Please  note  that  as  part  of  Arena  Luci's  ongoing  commitment  to  continuous  product  development, 

specifications  are  subject  to  change  in  the  course  of  product  improvement  without  notice. Arena  Luci  is  not 

responsible for damages resulting from improper or different use than expected.

ING0008­WW

ING0008­W

Summary of Contents for ING0008­WW

Page 1: ... of sharp or metal objects Make sure that cables cannot cause trip hazard Do not attempt to dismantle and modify the unit Due to the high technological level of this unit any service maintenance should be performed by specialised operators Please contact your Arena Luci dealer for any operation When assembling make sure that the cable glands are tightened for a watertight seal Avoid installing the...

Page 2: ...on is complete the unit is at the same level of ground surface or floor that is the upper side of recessed box should match the finished surface A the inground box must be placed on a layer of draining pebbles with a minimum thickness of 30cm in order to make easier the flow of rain water and avoid the lift of moisture inside the box Keep in mind that at the end of the installation the line joinin...

Page 3: ...ed to use ca bles with at least 2 5mm2 cross section or larger according to the voltage drop calculations Also the light can be dimmed using an external optional PWM dimmer not included Please refer to the instruction manual of the dimmer for connection details However due to the internal electronics the regulation is not smooth and takes place at discrete levels When choosing the proper power sup...

Page 4: ...2014 GPSD 2001 95 CE Warnings Disposal of Old Electrical Electronic Equipment applicable in the European Union and other European countries with separate collection systems The product shall not be treated as household waste but must be handed over to the applicable collection point for the recycling of electrical and electronic equipment By ensuring this product is correctly disposed you will hel...

Reviews: