background image

Proline RGB Color LED Controller

With RF Remote Control

Model # 713420

Introduction

This LED controller is designed to drive constant voltage 
RGB LED products such as LED tape light or LED 
fixtures in a voltage range of 5–24 volts DC. The receiver 
works with the RF wireless remote control, which allows 
the user to choose between multiple colors, adjust 
the LED brightness, and select dynamic effects.

Receiver & wiring

24mm

72mm

87mm

1

2

3

1. Input – from power supply

The controller input and output voltage range is 
5–24 volts DC. Make sure the LED lighting voltage is 
within this range and below the rated wattage of the 
power supply. Connect input wires from the power 
supply to the controller as indicated by the polarity 
markings on the controller (+ to + and – to –).

2. Output – to LED lighting

Observe polarity indicated on the controller  
when connecting to LED lighting (+ to +,  
G to G, R to R, and B to B).

Make sure the voltage of the LED lighting is the 
same as the power supply and the maximum 
load doesn’t exceed that of the controller.
CAUTION: Shorting of output cables could cause 
permanent damage to controller. Make sure 
cables are well insulated from each other.

3. Controller status indicator

This light shows the controller status as follows:

Steady green: Normal working mode
Single green blink: Command received
Long single green blink: Mode or color cycle limit reached
Long single yellow blink: Brightness or speed limit reached
Red flash: Overload protection
Yellow flash: Overheat protection
Green flash 3 times: New remote control paired

4. Wiring diagram

Connect the power supply to the controller input 
and the controller output to the LED lighting. 
The output voltage of the power supply must 
be the same as the voltage of the LED lighting. 
Make sure all power cables are conected 
securely and insulated before powering on.

LED

Controller

5–24V DC

Output

Power Supply

5–24V DC

5–24V DC

100/230V

AC Power

LED

Lighting

Remote Control

7

6

5

8

5. On / Off

Press the “|” key to turn on controller or the “0” 
key to turn off. The controller will remember 
the controller state when powered off, and will 
return to that state when powered back on.

6. RGB color setting

Press the “COLOR+” and “COLOR–” keys to 
scroll through all the color options. The colored 
keys are shortcuts for preset colors. Press the 

 and the   keys to adjust color brightness.

1

2

3

Compact

Size

Wide Voltage

Range

High

Power

Full Safety

Protection

Wireless

Remote

Reviews: