Top
Auxiliary
Lock
9
8654 Hinged Security Door Lock
3 Point Kit and Standard Lock Installation
Fitting the Actuator Bar and Auxiliary Locks
Note: For ease of fitment remove door from the door frame.
- Assemble the Actuating Bar and Rods as shown prior to
fitting to the door stile. With the “TOP” mark facing the front.
- Keep the locating lugs of the Actuating Bar facing the front edge of
the door.
-
Insert the Actuator Bar and rod assembly through the top cut-out
and slide it through the door stile.
- With the Auxiliary locks in the locked position (as shown),
Important:
Connect the top Auxiliary lock first to the end of the rod
followed by the bottom Auxiliary lock.
- Then push them both into the door stile.
Rod
Fitting Central Lock
With the central lock in the factory set
Deadlock
position,
insert into the stile. Locate and engage the lug on
the Actuating Bar with the lock, then secure with screws.
Important:
The lock must be installled in the position shown,
product warranty cannot be assured if installed upside down.
Fitting Cylinder & Spindle
- Insert cylinder so cam turns towards front of door.
- Losely fix cylinder with screw.
- Then insert spindle into lock body.
2
Lever Handing
If necessary prepare escutcheon by rotating levers 180 degrees
downwards to required handing position.
6
Fitting Escutcheon
- Fit escutcheon with snib on the inside face of the door.
- Ensure snib is to 90 degrees in the direction of the lever..
- Secure inside and outside escutcheons with screws and
screw hole plugs.
Securing Top and Bottom
Auxiliary Locks
Drill a 3mm hole through bottom hole
in the Auxiliary locks, secure with
fixing screws.
1
Drilling Hole in Top and Bottom Auxiliary Locks
- Gently push the top Auxiliary lock upwards to retract the hook bolt.
- Then drill a 3mm hole in the centre of the slotted hole.
- Repeat this step for the bottom Auxiliary lock.
12
Test Safety Mode:
Important:
Release button above hook bolt must be depressed.
Rotate key or snib 90 degrees towards the lever:
- Padlock symbol is visible.
- Inside and outside levers are locked.
- Auxiliary hook bolts are thrown and locked, push hook bolts upwards
to check.
- Repeat
STEP 6
to return lock to Passage mode.
Test Deadlock Mode:
Important:
Release button above hook bolt must be depressed.
Rotate key 180 degrees towards the lever:
- Snib rotates 90 degrees towards the lever, padlock symbol is visible.
- Inside and outside levers are locked.
- Auxiliary hook bolts are thrown and locked, push hook bolts upwards
to check.
Important: Reposition top and bottom Auxiliary locks if
necessary to achieve Safety and Deadlock modes, then
fully tighten fixing screws in STEP 8.
Bottom
Auxiliary
Lock
3
4
Release
Button
10
Locating Lugs
Actuator Bar
Stile
Spindle
Cylinder
‘o’
Ring
Top
Lug
5
Cam
7
Fixing Screw to Top and Bottom Auxiliary Locks
- Gently push the top Auxiliary lock upwards to retract the hook bolt.
- Lightly fix screw in slotted hole.
- Repeat this step for the bottom Auxiliary lock.
8
Passage Mode
With the central lock in the factory set
Deadlock
position, insert key
and rotate 90 degrees away from the lever to the unlocked position
or
Passage
mode. Snib rotates to the vertical position.
Release
Button
Depress Release
Button
Depress Release
Button
11
Snib
Hook
bolt
retracted
Q50083 Iss: A 0312
