background image

 

Securitron Magnalock Corp. 

www.securitron.com 

ASSA ABLOY, the global leader 

 

 Tel 

800.624.5625 

techsupport@securitron.com 

in door opening solutions

 

 

 

 

 

 

 
 

 

© Copyright, 2013, all rights reserved 

 

PN# 500-20760

 

 

Page 1  

Rev. A, 06/13 

 
 

DK-38 Installation & Operating Instructions 

 

Introduction 

The DK-38 Digital Keypads by Securitron offer Wiegand output for universal compatibility with 
access control systems or the DKC Digital Keypad Controller by Securitron. The 3x4 illuminated 
keypad features a flush-mount stainless steel faceplate.  
 

DK-38 keypads are shipped in ‘Wiegand mode’ from the factory. When interfacing with 
the DKC, please change the keypad to ‘Character mode’ and ensure that ‘Character’ is 
selected in the DKC Programming Tool. The advanced programming features available 
in Character mode allow a user to customize the operation of the DKC to fit the specific 
needs of their installation. Instructions on how to change from Wiegand to Character 
mode are found in the 

Changing to Character Mode

 section below.  

 
Box Contents 

Keypad with mounting hardware pack 

 

Installation & Operating Instructions 

 

Surface Mount Wall Box 

 

Flush Mount Wall Box 
16’ of wire 
 

Specifications  
 
Power Selection  

12V or 24V DC @ 100mA max 

 
Environmental 

Operating temperature: -10° to 140°F (-23° to 60°C) 
Storage temperature: -10° to 150°F (-23° to 65°C) 
Humidity: 0% to 95% relative humidity 

 
Installation   

The DK-38 can be installed using one of two wall boxes; a surface mount wall box or a flush 
mount wall box. Note that the DK-38 can be used outdoors with the optional rain cover 
(Securitron part number WCC) which will allow the DK-38 to be mounted in outdoor locations 
not directly exposed to rain or snow. Additionally, when used outdoors a weatherproof gasketed 
wall box is recommended (Securitron part number WBB). 
 
Note that the surface mount wall box must be used for the tamper feature of the DK-38 to 
operate properly. Once the DK-38 is wired per the wiring diagram in the 

Wiring

 section of this 

document, gently install the spring onto the push button switch with the tapered side of the 
spring facing downwards towards the PCB. The spring will allow the tamper feature to operate 
with the surface mount wall box.  
 

Reviews: