• The price/performance standard in side-address studio
condenser microphone technology
• Ideal for project/home-studio applications
• High SPL handling and wide dynamic range provide unmatched
versatility
• Custom-engineered 16 mm low-mass diaphragm provides
extended frequency response and superior transient response
• Cardioid polar pattern reduces pickup of sounds from the sides
and rear, improving isolation of desired sound source
• Pivoting, threaded stand mount attaches securely for easy and
precise placement of the microphone
The AT2020 is intended for use in applications where remote power
is available. It requires 48V DC phantom power, which may be
provided by a mixer or console, or by a separate, in-line source
such as the Audio-Technica AT8801 single-channel and CP8506
four-channel phantom power supplies.
Output from the microphone’s XLRM-type connector is low
impedance (Lo-Z) balanced. The signal appears across Pins 2 and
3; Pin 1 is ground (shield). Output phase is “Pin 2 hot” – positive
acoustic pressure produces positive voltage at Pin 2.
To avoid phase cancellation and poor sound, all mic cables must be
wired consistently: Pin 1-to-Pin 1, etc.
Avoid leaving the microphone in the open sun or in areas where
temperatures exceed 110° F (43° C) for extended periods.
Extremely high humidity should also be avoided.
AT2020 SPECIFICATIONS
†
ELEMENT
Fixed-charge back plate
permanently polarized condenser
POLAR PATTERN
Cardioid
FREQUENCY RESPONSE
20-20,000 Hz
OPEN CIRCUIT SENSITIVITY
–37 dB (14.1 mV) re 1V at 1 Pa*
IMPEDANCE
100 ohms
MAXIMUM INPUT SOUND LEVEL
144 dB SPL, 1 kHz at 1% T.H.D.
NOISE
1
20 dB SPL
DYNAMIC RANGE
(typical)
124 dB, 1 kHz at Max SPL
SIGNAL-TO-NOISE RATIO
1
74 dB, 1 kHz at 1 Pa*
PHANTOM POWER
48V DC, 2 mA typical
REQUIREMENTS
WEIGHT
(less accessories)
12.1 oz (345 g)
DIMENSIONS
6.38" (162.0 mm) long,
2.05" (52.0 mm) maximum body
diameter
OUTPUT CONNECTOR
Integral 3-pin XLRM-type
ACCESSORIES FURNISHED
Stand mount for
5
/
8
"-27 threaded
stands;
5
/
8
"-27 to
3
/
8
"-16 threaded
adapter; soft protective pouch
†In the interest of standards development, A.T.U.S. offers full details on its test
methods to other industry professionals on request.
*1 Pascal = 10 dynes /cm
2
= 10 microbars = 94 dB SPL
1
Typical, A-weighted, using Audio Precision System One.
Specifications are subject to change without notice.
Audio-Technica U.S., Inc.,
1221 Commerce Drive, Stow, Ohio 44224
Audio-Technica Limited,
Old Lane, Leeds LS11 8AG England
www.audio-technica.com
P#1423-10500 P51722-EN ©2004 Audio-Technica U.S., Inc. Printed in China
AT2020
CARDIOID CONDENSER MICROPHONE
12" or more on axis
100
50
200
LEGEND
10k
5k
1k
500
2k
20k
Frequency in Hertz
Frequency Response
Response in dB
10 dB
SCALE IS 5 DECIBELS PER DIVISION
Polar Pattern
200 Hz
LEGEND
5 kHz
1 kHz
8 kHz
240
180
210
270
300
330
0
150
120
90
30
60
