Document Version: AU-A1ZBSCCX_V3_18
www.auroralighting.com
MODEL
AU-A1ZBSCCX
INPUT VOLTAGE (V)
12-24V DC
INPUT CURRENT
8A @ 24V DC / 12V DC
OUTPUT VOLTAGE
12-24V DC
NUMBER OF OUTPUTS
1 (includes warm white and cool white)
MAX LOAD
96W @ 24V DC per output
48W @ 12V DC per output
AMBIENT TEMPERATURE LIMITS
-20°C~+50°C
IP RATING
IP20 (Indoor Use Only)
NUMBER OF OPERATING CYCLES
1E4
CIRCUIT DISCONNECTION
Electronic disconnection
PROTOCOL
ZigBee 3.0
CONDUCTOR TYPE & SIZE
Twin and Earth 0.75~1.5 mm
2
(UK)
Flat x2C+E 0.75~2.5 mm
2
(Australia)
FREQUENCY BAND
2.405 - 2.483GHz
MAX OUTPUT RF POWER
12.66dBm
INSULATING MATERIALS
Polycarbonate
GLOW-WIRE TEMPERATURE
850
°C
PROTECTIVE DEVICE
100°C Recoverable temp control
• There are no restrictions of use.
• Installation must be carried out in accordance with the latest edition of the
Wiring Rules by a qualified electrician.
• Earth terminal is for Termination only.
• Hereby, Aurora Limited declares that the radio equipment type
AU-A1ZBSCCX is in compliance with Directive 2014/53/EU. The full text
of the EU declaration of conformity is available at the following internet
address:
www.auroralighting.com/ProductDetail/AU-A1ZBSCCX
2
4
8
Download / control through the
AOne App
7
USING THE APP TO CONNECT THE LED STRIP
CONTROLLER TO THE HUB
1. Download the AOne App from the App Store.
2. Follow instructions on the App to send the hub into pairing mode and pair
your devices (further details below).
3. Put the controller into pairing mode by:
a) Connecting the controller to a power outlet and turning on the power, or,
b) Pressing the pairing button for 3 seconds, or,
c) Powering the controller off for a minimum of 2 seconds and back on
again 6 times. The on periods must be between 0.5 - 1.5 seconds.
The LED Strip will flash twice to indicate it has entered pairing mode.
The LED Strip will flash a third time to indicate that it has successfully
paired with the hub.
The controller can then be controlled using the AOne App.
LED Strip
220-240V
Mains Supply
5
IMPORTANT INFORMATION:
• The strip controller works on 12V/24V DC, it cannot be
used with 220-240V AC directly.
• Remove any existing dimmers from the circuit.
• The strip controller fits between the non-dimmable LED
driver and LED strip (LED driver NOT included).
• We recommend LED strip below 10W per metre can run a
maximum of 10m and for LED strip above 10W per metre
a maximum of 5m. This is based on an incoming cable
between driver and start of LED strip of 5m.
• For further details please check specific LED strip data.
1
CW-
+
+
+
V+
V-
WW-
LED D
river
CABLE T
O
LED STRIP
+ - -
12-24V DC
12-24V DC
CABL
E
CABLE FROM LED DRIVER
3
6
Pairing
button
