Austral Lock ELEGANCE PUSH2GO, Illustrated Fitting Instructions

oem1doc03_R2

●

Lockbody screws.

ELEGANCE 

P U S H 2 G O

for hinged security doors

ILLUSTRATED FITTING INSTRUCTIONS

●

Lockbody screws.

●

Lockbody screws.

1. 

LOCKBODY INSTALLATION

3. 

EXTERIOR FURNITURE

4. 

INTERIOR FURNITURE

5. 

INSTALL THE FURNITURE

●

The 

Sticker

 on the rear of 

the 

Lockbody

 is to assist 

in easy installation. - Do 

not remove. 

●

If the 

Sticker

 has been 

broken or removed, en-

sure that the 

Rear Slide

is pushed completely 

down before assembling 

the 

Lockbody

 into the 

door cutout. 

●

Insert the 

Lockbody

 into 

the door cutout

●

Secure the 

Lockbody

with the two #8x13mm 

Lockbody screws.

Sticker

Rear Slide

2. 

CYLINDER INSTALLATION

●

Depress the 

Auxiliary Bolt

to ensure the 

Main Bolt

 is 

fully extended.

●

Assemble the 

Cylinder

through the lock so the 

Cyl-

inder

 protrudes equally from 

both sides. 

NOTE : the 

Cylinder Cam 

must rotate as shown below. 

(cam turns towards front of 

door)

●

Insert the 

Key

 and turn to 

locked position.

●

Insert #10 x 38mm 

Cylinder 

Screw

 & tighten. 

NOTE : test, 

Main Bolt 

should not depress.

●

Turn 

Key

 to unlocked posi-

tion and remove 

Key

.

Cylinder 

Screw

Main 

Bolt

Auxiliary 

Bolt

Cylinder

Cam operation

Handle 

Rod

Cylinder 

Cam

IMPORTANT : If installing PUSH2GO with a multipoint acces-

sory kit, be sure to follow the cylinder installation procedure 

within the multipoint kit instructions.

●

Select the 

Exterior Handle

assembly.

●

If the 

Handle

 does not point 

towards the door hinges, 

remove it from the 

Handle 

Plate

 and exchange with 

the other handle.

●

Ensure the 

Locking Hub

 is 

rotated so the pip is closest 

to the door edge.

rotate 

Hub

 so that 

the pip is closest 

to door edge

●

Select the 

Interior Handle 

assembly with 

Snib Lever 

hole.

●

Hold the 

Snib Lever

 hor-

izontally and insert it into 

the snib lever hole, turn it 

until vertical to secure it.

●

While holding the Snib 

Lever vertical, place the 

Lever Assembly

 against 

the door.

●

Insert the 

Handle Rod

through the 

Lock Body

.

●

Locate the 

Exterior 

Handle

 assembly over 

the 

Lock Body

.

●

Engage 

Snib Lever

 into 

Locking Hub

.

●

Fit the two 

#8x32mm 

Furniture screws

.

PLEASE TURN OVER

Austral 

宏

ock