Rack fully assembled
USE
for outer legs and inside leg
(F) M10 x 20 Bolt
(H) Flanged Washer (on top)
(D) M10 Zinc Washer (underneath)
(E) M10 Zinc Nut (underneath)
Australian Barbell Company
54 Bond St West, Mordialloc, VIC 3195
ABN 29 004 420 848
P 03 9580 5945
F 03 9580 7123
info@australianbarbellco.com
www.australianbarbellco.com
DUMBELL RACKING
ASSEMBLY INSTRUCTIONS
10 PAIR RACK
To ensure that your racking is assembled correctly, please follow these instructions carefully. All letters in brackets on this page refer to
the
‘Part No.’
on the reverse
‘PART LISTING’
page.
Step 1:
Bolt Cross Piece (C) to Legs (A) as shown. This
must
be done first, before proceeding with any other assembly. Take note of the
information on “Plastic Bolt Head Covers” at the bottom of the page.
Note:
Legs (A) can be used in any position - there is no specific outside leg.
Repeat
Step 1
for the other leg (A) and Cross Piece (C) being used on right-hand side of rack. Ensure to fit a Flanged Washer (H)
underneath each Bolt-head (F/G) and M10 ZInc Jam Nut (E) that is used. Once both cross-pieces are fitted, tighten all bolts. Do not fit
Plastic Bolt-Head Covers (I) at this stage.
Step 2:
Fit the Dumbell Supports (B) to Legs (A). This can be done in any order. Take note of the stickers on the Dumbell Supports to
determine where each Dumbell Support (B) sits on the Legs (A) and that they are orientated correctly – there are diferent supports for
the front and back of the top and bottom tiers. This is much easier to do with 2 people – one to hold the supports in place, the other to
insert bolts etc.
PLASTIC BOLT HEAD COVERS (I)
NOTE:
Your Australian Barbell Racking has been supplied with special Plastic Bolt-Head Covers (I).
These are used to cover
all
bolt heads as well as nuts used to attach the Legs (A) to Cross Piece (C).
They are
not
used to cover the M10 Zinc Jam Nuts (E) used on the underside of the Dumbell Supports
(B). When assembling racking, please follow these instructions to ensure they are fitted correctly.
i) Ensure that the flange on the Flanged Washer (H) is facing upwards and on the side that the head
of the bolt will be on.
ii) After all bolts have been fully tightened, push the Plastic Bolt-Head Cover (I) down onto the steel
washer and it will snap into place.
Bolts (G) should
remain protruding
on right hand side
of centre leg.
IMPORTANT:
Same as left side,
but use M10 x 30 Zinc Bolt (G)
Cross Piece (C)
Right-hand
Outside Leg (A)
Centre
Leg (A)
USE
(F) M10 x 20 Zinc Bolt
(H) Flanged Washer
(Inside and Outside)
(E) M10 Zinc Jam Nut
