Operating instructions for Avansa 500 W backup power supply
Thank you for purchasing this power and trust in AVANSA®. Please read carefully the instructions for
installation and safe use
This product belongs to a group of professional UPSs specially designed and manufactured to
continuously supply boilers for solid fuels in the event of a main power failure. In the event of a
power outage, the backup power supply (UPS) provides instantaneous power from the battery, so
the water pumps will keep running and the boiler will cool down safely.
WARNING! It is only a safety device that is used only in the event of a power outage.
This system can be used to ensure the operation of other electrical appliances that require stability
and stable electrical energy parameters. This product should not be used as a converter (with
unlimited 12 V battery operation).
The main feature of this device is the input power of a battery-powered curve. The curve is a pure
sinusoid, identical to the main power source of your home. When the main energy from your home
is turned on, the backup source will charge the battery and ensure long battery life. The Backup
(UPS) works only with an external 12V battery (for a 1050W model with a 24V battery). Only a lead-
acid battery type should be used, as the backup source is designed to charge this type of battery. Use
of gel batteries may cause explosions.
WARNING! Be careful when handling the battery. Attach metal objects (such as bracelets, chains,
watches, rings ... etc) when attaching a backup source. Due to the fact that the electrical current can
be short-circuited and the metallic material can be subsequently discharged to the consumer's body.
When connecting the battery, keep polarization: the red (+ positive) cable will be connected to the
te battery and the black (-negative) wire will be connected to the terminal terminal -. The
metal connectors are used to connect the cable to the battery terminals. Tighten the connector
using the key to secure the fixed contact. Also observe all the rules in the battery user manual.
Install the UPS in a dry place, free of humidity, out of reach of water or snow. The location of the UPS
must be large enough to prevent the backup system from cooling. In addition, this site should be
free from dust and coal dust that could block the back-up fan. At the installation site, it should be
well ventilated to prevent overheating. To avoid electrical shock, ensure that all cables are in good
condition and free of isolation. Running and UPS may cause sparking. The backup source should not
be installed in flammable environments.
WARNING! The UPS only works when it is connected to an external battery. It should not be used
without connecting the battery. After the battery is plugged in, plug the main power cable into a
power outlet (230V, 50Hz) with grounding from the mains mains. On the back of the power supply,
connect the device that you want to work in the event of a power failure. Follow these steps:
connect the battery, connect the main power supply, and then connect the consumer (device) to a
backup power source (UPS). To turn on the power, press and hold the power button (ON / OFF) for 4
seconds.
Operation starts with automatic battery voltage detection. If the battery voltage falls below 10.8V, it
may be assumed that the battery is damaged and can not be started. If the battery is OK and the
battery is not charging after
