Axiomet AX-582B
1. Safety Notices
The instrument meets IEC 1010 clauses (the safety standards promulgated by International Electrotech-
nical Commission) in terms of design, and shall be used after reading the safety notices.
• Do not input values over the maximum range of each measurement to avoid damages of the Meter.
• The voltage of below 36V is safe. When the voltage measured is higher than DC36V or AC25V, users
shall check when the multimeter probe is reliably contacted, correctly connected, and well insulated, in
order to avoid electric shock;
• Be sure to keep the test leads off the testing points when switching function or range.
• Select correct function and range to avoid fault operation.
• Please do not measuring before battery isn’t installed and back cap isn’t firm.
• Do not input any voltage when measure resistance.
• Always remove the test leads before replacing the battery or fuses.
• Do not input a current higher than 20A when measuring the current.
• The following safety symbols may appear in this manual or on the instrument:
•
Attention! Exists high voltage,
GND,
Dual insulation,
Must refer to manual,
Low battery
2. Specification
2.1. General feature
• Display mode: Liquid crystal display;
• Max display: 1999 (3 ½) digits automatic polarity display.
• Measuring method: Dual-integral A/D conversion;
• Sampling rate: Around 3 times/ second;
• Ultra-range display: Highest position displayed as “OL”;
• Low voltage display: Appearance of the sign
;
• Working environment: (0~40)°C, relative humidity <80%;
• Power supply: 9V battery
• Volume (dimensions): 190 x 88,5 x 27,5mm (L×W×H)
