S5-ACK01039K01(AKK09412)
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD, AND RECEIPT.
Page 2
PARTS LIST
DESCRIPTION
ORDER PART # QTY
1
A
B
C
D
E
F
1
HW0861
HW0008
FOOT CAP
FACTORY ASSEMBLY
4
* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE
Ø8.5 X 1.5 MM
WASHER
FC0614
5/16" X 45 MM BOLT
HW0074
8
TABLE TOP
TABLE LEG
8
Step 1:
Do not
attempt assembly if any parts are missing or damaged.
Step 2:
Hand tighten only
2-3 turns.
Step 3:
Do not over tighten
Remove all protective materials and set parts on a flat, non-abrasive surface. Identify parts packed in the carton against the parts list.
If you are missing any parts or unsure how to proceed with assembly, call our Customer Service Center at 1-800-416-3511.
Attach a leg to the table by using the two bolts and washers
as shown in the diagram. Guide the bolts through the holes in the leg, into the pre-drilled holes in the table top.
Repeat for the three legs.
After making any necessary adjustments to the alignment of the parts, use the hex bolt driver to tighten all bolts. Repeat until all
bolts are tight.
. Over tightening may strip bolts. Cover all bolts with covers. Your table is now ready for use.
If you have any questions, please call our Customer Service Center at 1-800-416-3511.
Place the table top upside down on a flat, non-abrasive surface.
IMPORTANT NOTE: Damage to welds or frames resulting from over tightened bolts or improper assembly is not covered under
our warranty. Please read all instructions carefully before assembly. If you have any questions regarding your assembly, call our
Customer Service Center at 1-800-416-3511.
BOLT COVER
HW0442
8
HEX WRENCH
C
E
D
A
B
FOOT CAP
AT73552
AT73553
