Lift ’n Glide
TM
Retractable Cover System
READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING INSTALLATION
Kit components
1.
Right side assembly
2.
Left side assembly
3.
Hardware bag & template
Hardware Bag contents
•
20 x Phillips 1 ½” pan head screws
Tools Needed
1.
Tape
2.
7/16 wrench (2)
3.
#2 Phillips screwdriver
4.
Drill motor with 1/8” drill bit
ASSEMBLY INSTRUCTIONS
I.
Locate Mounting points on spa cover
1.
Left and Right orientation is determined by standing at the back of the spa. Covers on the
Grandee (G) and Landmark (S) open from side to side, so Left and Right orientation is
determined by standing at the back of the spa cover. Note the position of the cover warning
label and the equipment compartment. Position the cover on the spa, ensuring that the rear
half of the cover (opposite the warning label) is positioned on the rear half of the spa. (See
above)
Page 1
5/14/2007 - Rev B.
US Patent #7,010,833
2.
Unfold and place the template on the left side of
the cover as shown with the side marked “Left
side” facing upward.
3.
Fold the tabs of the template where marked and
tape down to the rear and side of the spa cover
as shown.
4.
Drill the hole (B) marked on the template with
the 1/8” drill into the side of the cover. The hole
will go through an aluminum plate.
5.
Remove the template and repeat the procedure
on the right side of the cover. Make sure the template is turned over and the side marked
“Right side” is facing up. Remove the template when finished.
