background image

PRODUCT CODE: BTBLANKET120

12 Month warranty

www.baintech.com.au

120W

 

SOLAR BLANKET

BTBLANKET120

GREAT  FOR

Included accessories:

PWM Regulator

6m Power Lead

Red Anderson 

Connection

Alligator Clamp 

Connector

Efficiency

Up to 24%

Model

120W (Blue)

Output

5.5V/2A & 18V/6.6A

Solar Cell

Monocrystalline Sunpower solar cell

Rated Power

18V 120W

Unfolded Size

1560mm H x 770mm W

Weight

3.6kg

Charge controller

12V/24V 20A solar charge controller

Operating Temp

-35� to +55�

Go off-grid with the Baintech 120w Solar Blanket. Designed to charge 
your 4WD, RV and Marine batteries, this lightweight and compact 
blanket will produce up to 6.6A in optimal conditions.

Designed with ease of use in mind, the simple plug and play Anderson 
plug connection is secure, safe and easy to connect.

The Baintech blanket comes with a smart 20amp 12/24v PWM with 
chemistry profiles for 3 types of batteries – sealed, GEL, and Flooded 
(see separate PWM manual included)

•  High efficiency

•  Compact

•  Light weight

•  Easy to use – plug and play

•  All accessories and PWM included

BAINTECH 120W  

SOLAR BLANKET

Summary of Contents for BTBLANKET120

Page 1: ...controller Operating Temp 35 to 55 Go off grid with the Baintech 120w Solar Blanket Designed to charge your 4WD RV and Marine batteries this lightweight and compact blanket will produce up to 6 6A in optimal conditions Designed with ease of use in mind the simple plug and play Anderson plug connection is secure safe and easy to connect The Baintech blanket comes with a smart 20amp 12 24v PWM with ...

Page 2: ... solar blanket offers a simple plug and play solution The blanket comes with a PWM Solar Controller The Solar Controller is normally used when there is no internal controller in your equipment ie when you want to charge your car battery or a secondary battery in a trailer OUTPUT Connect the Anderson connector with solar charger controller and then connect the Alligator clamps to your batteries Alw...

Page 3: ...t the battery first in order to allow the controller to recognize the system voltage 3 The battery fuse should be installed as close to battery as possible The suggested distance is within 150mm 4 The VS AU series is a positive ground controller Any positive connection of solar load or battery can be earth grounded as required NOTE Please connect the inverter or other load that it has the large st...

Page 4: ...ns Troubleshooting The LCD is off during daytime when sunshine falls on PV modules properly PV array disconnection Confirm that PV wire connections are correct and tight Wire connection is correct LCD not display 1 Battery voltage is lower than 9V 2 PV voltage is less than battery voltage 1 Please check the voltage of battery At least 9V voltage to activate the controller 2 Check the PV input volt...

Reviews: