Configurable Gateway with 0 to 10V analog inputs and 0 to 10V analog outputs
IP67 Base
2.4 GHz
IP20 Base
900 MHz
For additional information, upda-
ted documentation, and acces-
sories, refer to Banner Engineer-
ing's website,
.
The SureCross
®
wireless system is a radio frequency network with integrated I/O that can operate
in most environments and eliminate the need for wiring runs. Wireless networks are formed around a
Gateway, which acts as the wireless network master device, and one or more Nodes.
• Wireless industrial I/O device with four 0 to 10V analog inputs and four 0 to 10V analog outputs
• 10 to 30V dc power input
• DIP switches for user configuration
• Modbus serial interface
• Site Survey analyzes the network’s signal strength and reliability and displays the results on the
Gateway's LCD
• Frequency Hopping Spread Spectrum (FHSS) technology and Time Division Multiple Access
(TDMA) control architecture ensure reliable data delivery within the unlicensed Industrial, Scien-
tific, and Medical (ISM) band
• Transceivers provide bidirectional communication between the Gateway and Node, including
fully acknowledged data transmission
• Lost RF links are detected and relevant outputs set to user-defined conditions
• The DX80...C models are certified for use in Class I, Division 2, Group A, B, C, D; Zone 2 (Cate-
gory 3G) Hazardous Locations when properly installed in accordance with the National Electrical
Code, the Canadian Electrical Code, or applicable local codes/regulations (see Specifications)
Models
Frequency
Environmental Rating
I/O
DX80G9M6S0P0V4V4
900 MHz ISM Band
IP67, NEMA 6
Inputs: Four 0 to 10V analog
Outputs: Four 0 to 10V analog
DX80G2M6S0P0V4V4
2.4 GHz ISM Band
DX80G9M6S0P0V4V4C
900 MHz ISM Band
IP20, NEMA 1
Class I, Division 2, Group A, B, C, D Haz-
ardous Locations (see Specifications)
DX80G2M6S0P0V4V4C
2.4 GHz ISM Band
Internal antenna models are also available, but are not UL Listed. For more information, contact your local Banner Engineering Corp.
representative.
WARNING: Not To Be Used for Personnel Protection
Never use this device as a sensing device for personnel protection. Doing so could lead to serious
injury or death. This device does not include the self-checking redundant circuitry necessary to allow its
use in personnel safety applications. A sensor failure or malfunction can cause either an energized or de-
energized sensor output condition.
The SureCross
®
DX80 Wireless Network
Gateway
Node
Node
FlexPower Node
and Battery Supply Module
The SureCross
®
DX80 wireless I/O network provides reliable moni-
toring without wiring or conduit installation. The SureCross wireless
network operates independently or in conjunction with a host system,
PLC, and/or PC software.
Each wireless network system consists of one Gateway and one or
more Nodes. Devices ship with factory-defined discrete, analog, or a
mix of discrete and analog inputs and outputs.
The SureCross
®
DX80 network is a deterministic system—the net-
work identifies when the radio signal is lost and drives relevant out-
SureCross DX80 Gateway
P/N 136325 Rev. F
5/24/2013
0 136325
8
