Installation Manual
©
2020
bas
alt
e v
3.
0
SENTIDO RS485
A
RGB LED
B
Temperature sensor
C
Touch sensor (1-4)
D
Touch-sensitive surface
E
Transparent window
Safety instructions
Before operating the unit, please read this manual thoroughly and retain it for future reference.
Failure to observe these instructions might damage the device. The device may only be installed and
connected by professional electricians.
All relevant rules and regulations valid in the country of use, as well as RS485 guidelines, apply.
Description
Sentido RS485 is a touch-sensitive switch compatible with the Basalte Serial.link. The Sentido RS485 can be
combined with all Sentido and Enzo cover plates, either two-way or four-way. The separate touch-sensitive
surfaces of Sentido each control various functions, using both short and long press. By touching more than one
surface at the same time, additional comfort functions can be activated including room toggle, scene sequencer
and RGB sequencer. The multicolour LED backlight provides status feedback and can be used as nightlight. The
Sentido also has a built-in temperature sensor.
Components
Important advice
•
Never connect the device to 110 V / 230 V.
•
Avoid obstacles which might obstruct the proper mounting of the cover to the switch, such as
round headed screws, plastering or textured wall paint.
•
Installing a Sentido on a metal wall or a mirror surface might cause the device not to function
properly.
•
The minimum gap between 2 Sentido or Deseo must be at least 4 cm (1.6in).
•
Do not install any device nearby that might cause interference such as fluorescent lights or RF
devices.
Sentido front cover 2 way
Model No. 201-xx
(not included)
Sentido front cover 4 way
Model No. 202-xx
(not included)
Sentido RS485 front
Model No. 0200-01
A
B
C
D
E
1
2
3
4
D
E
minimum gap = 4 cm (1.6")
