ASSEMBLY INSTRUCTIONS
THANK YOU FOR PURCHASING THIS PRODUCT
For questions about this product, or for parts inquiries, please contact our Customer Service Center listed below.
Energy-Free Waterers
SF-2C, SF-4C, EF-1C, EF-2C, EF-4C
F-19857-8
TECHNICAL INFORMATION 70 110
Rev. 6-8-09 8-4-04
CUSTOMER SERVICE CENTER
PO Box 569
Columbus, NE 68602-0569
Ph: 1-800-447-2751
Fax: (402) 563-7447
CONGRATULATIONS
, you have just
purchased one of the most efficient
Energy-Free waterers ever manufactured.
The thermos bottle type construction will
hold the heat from the earth temperature
of the water and keep your Energy-Free
waterer warm in the winter and cool in the
summer. The closed dark interior inhibits
growth of bacteria, scum and algae.
The smooth rounded plastic exterior is
maintenance free and prevents injuries to
animals. It also prevents tongue injuries
from frigid steel.
All Behlen Country Energy-Free
Waterers carry a 5 year limited
warranty on the body and a 1 year
limited warranty on valves and
controls.
Installation and Recommendations
Please read over these instructions to make
sure you have all necessary components for
your installation. To ensure proper operation
in cold weather, it is highly recommended that
you purchase the optional Poly Earth Tube and
Shut-off Valve Kit.
Contact your dealer for
necessary items.
The Energy-Free waterer depends on water
entering the unit at ground temperature
(50-55° F.). This generally requires the 3/4" water
line to be at least 2 ft. below the frost line for
maximum performance.
Also, a minimum number of animals must use the
waterer to ensure that enough fresh water is
cycled through the waterer daily to prevent
freezing.
Energy-Free
Waterer
Minimum Number
of Animals
Gallon
Capacity
SF-2C
20
40
SF-4C
30
80
EF-1C
12
15
EF-2C
20
20
EF-4C
30
30
Under certain conditions, some icing may occur
on top of the balls in cattle units. Periodically
remove the ice with hot water or by tapping on the
balls, physically removing any ice.
We recommend a Behlen Insulated Earth Tube be
used. Where a waterer is replacing an electric
waterer and the Poly Earth Tube is less than 12"
deep and uninsulated, you may need to use heat
cable in the riser pipe. A 250 watt submersible
heater (52120088) is available for use when less
than the minimum number of animals are using
the waterer.
The drawings in these instructions provide slab
dimensions and approximate anchor locations for
various models. It is advisable to check the
waterer for exact dimensions for anchor locations.
This is because some variance due to the molding
process is normal and the dimensions on the
waterer may vary slightly from the drawing. Anchor
bolts (not provided) may be set in concrete or
anchors may be drilled in after the fountain is set
in place. Use anchors for 5/16" bolts.
NOTE:
The
slab should be at least 4" larger than the waterer
on all sides.
Poly Earth Tube Installation Instructions
Your insulated Poly Earth Tube is designed to
contain the earth’s heat from below the frost line,
and keep the frost from penetrating through the
tube and freezing the water pipe.
