Mounting Instruction BAT-ANT-Protector m-f
Release 03 01/13
Technical Support
https://hirschmann-support.belden.eu.com
Mounting Instruction
Over Voltage Protector
BAT-ANT-Protector m-f
Safety instructions
Only qualified personnel are permitted to install the device in
accordance with the relevant national installation and safety rules. Its
usage is only permitted under the conditions stated and shown in this
instruction.
The data line protector and the equipment connected to it can be
destroyed by EM surges exceeding the given specification, e.g. due to
a direct lightning strike.
The operational voltage of the system/equipment to be protected must
not exceed the maximum permissible operating voltage (rated voltage)
of the data line protector.
Disconnect or switch off inline equipment when installing or removing
the protector.
Do not open the protector. Opening the data line protector will void the
warranty and may result in the accidental destruction of electronic
components.
WARNING
ELECTRIC SHOCK OR FALLING
Avoid mounting the antenna near power lines.
When installing an antenna from a ladder or elevating equipment, take
precautions to avoid falling and ensure the equipment is securely positioned
on solid ground.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
