Package contents
• Refrigerator water filter
•
Quick Setup Guide
Compatibility
Compatible with the following
branded filters:
LG®
LT800P, LT800PC, LT800PCS,
ADQ73613401, ADQ73613401-S,
ADQ73613402, ADQ73613402-S,
ADQ73613403, ADQ73613407,
ADQ32617801, ADQ32617703,
ADQ72910901,ADQ73613408,
ADQ75795104
Kenmore®
9490, 469490, 46-9490
Features
• NSF 42 and 53 certified to filter contaminants, including chlorine, cysts, lead,
mercury, carbofuran, benzene, and endrin
• Lasts up to six months or 200 gallons (757 L)
• Eliminates cloudiness for fresh, clear drinking water
Installing your water filter
• It is normal for black carbon particles to appear on the outside of your filter. This
happens when the filter is moved during shipping. It is safe, simply wipe them off.
1
Shut off the water supply, then turn off the water shutoff valve on your
refrigerator.
2
Locate the filter holder in the back upper right-hand corner of the refrigerator. To
open the filter cover, push in where indicated and the cover will drop down.
3
Remove the old filter by slowly rotating it counter-clockwise. A small amount of
water may drip down.
Note
: When you pull out the water filter, a little water may leak from the opening. This is
normal. To minimize the water leakage, keep the filter horizontal when you pull it out.
4
Insert the new filter into the water filter holder.
5
Slowly turn the new filter clockwise until it stops. The filter will click and lock into
place.
Note:
The filter connectors are large to prevent leaks. You might have to twist the filter hard
to make sure that the connection is secure.
6
Close the filter cover.
7
Turn on the water supply and run water through the dispenser for about five
minutes at 0.5 gpm (about 2.5 gallons or 9.5 L) to remove any trapped air and clear
the system.
CAUTION:
This filter should not be used with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the system.
8
Open the refrigerator door and make sure that no water leaks from the new filter.
Note
: If leaks occur, repeat the installation steps. If leaks persist, discontinue use and call
customer service.
WARNING:
To reduce the risk of property damage due to water leakage, this filter MUST be
installed in accordance with the manufacturer's specifications and instructions. This filter unit
must be replaced every 200 gallons (757 L) or 6 months. Failure to follow instructions and
operating specifications will void your warranty. Further, the manufacturer assumes no
responsibility or liability for damages arising out of misuse of the product.
Refrigerator
Filter
Quick Setup Guide
BE-LGLT800P531
Before using your new product, please read
these instructions to prevent any damage.
Resetting your change
filter indicator
• LG:
Press and hold the reset button
for three seconds. If this doesn’t
work, see the documentation that
came with your refrigerator.
• Kenmore:
The filter reset for
Kenmore refrigerators varies by
model. See the documentation that
came with your refrigerator.
Storage and maintenance
• Replace your filter every six months
or two hundred gallons (757 L) to
prevent bacteria and fungus growth
in your filter, supply lines, and
storage tank.
• Stored filters do not expire. Keep
your unused filters in a cool, dark,
and dry place until you need them.
• If you do not use your water
dispenser for more than four days,
run two gallons (7.6 L) of water
before using it to prevent bad
tasting water.
