Prior to use please
read all instructions
Suitable for most ‘A’ framed
wheeled walkers with a tubular
frame diameter of
25 mm and handle
diameter of 23mm
Suitable for most walking
sticks to a maximum
diameter of 23 mm
Do not attempt to
place anything
other than a walking
stick into the holder
Attaching the upper clip
The upper clip must be mounted to
the handle tube of the wheeled walker
(on either side as preferred). To allow
sufficient space, the handle cannot be set
on the lowest height setting.
Unscrew the 2 bolts holding the upper
clip bracket using the hex key provided.
With the clip facing outwards, place the
brackets around the handle tube on your
preferred side. Reinsert both bolts and
tighten.
Note that depending on handle tube
size, bracket may not close together
completely however it must be sit firmly
and securely around the frame without
movement up or down.
To attach the lower cup
The lower cup should be mounted just below the side
brace of the wheeled walker where possible, or on a
lower section of frame that does not interfere with the
operation of the side brace.
Unscrew the 2 bolts holding the lower cup bracket using
the hex key provided. With the cup facing outwards,
place the brackets around the frame (below the side
brace, where possible) on your preferred side. Reinsert
both bolts and tighten.
The cup must be mounted in a straight line to the clip.
Typically, both upper lower attachments sit
perpendicular to the frame however they may need to
be angled to suit the design of the individual wheeled
walker.
Ensure both upper clip and lower cup attachments are
securely attached to the frame before use.
Designed to attach to
the frame of a wheeled
walker for easy storage and
transportation of a walking
stick.
Can be attached to either side
of the frame as required.
Suitable for all BetterLiving wheeled
walker models excluding the Tri-Wheel.
Ø 23 mm
Stick
Ø23 mm
Handle
Ø25 mm
Frame
Handle
Frame
23 mm
25 mm
C L I P
C U P
Walking Stick Holder
S E T U P A N D O P E R A T I O N
