Chair seat
Please read these
instructions before use.
This shower chair is
designed as a temporary
seating aid only. Do not
use the chair as a step or
transfer device.
This product is suitable
for use in showers,
bathrooms or wet areas. It
is not suitable for use in a
swimming pool.
The Shower Chair is manufactured
from lightweight aluminium, for
increased resistance to corrosion,
with moulded plastic seat and
contoured back support.
Some basic assembly required
Adjusting the height
The chair is height adjustable to match individual
user or uneven surfaces. A series of holes along each leg allow
seat height to be adjusted from 490 mm to 590 mm.
One rear leg has additional incremental settings to allow for
more exact positioning on uneven surfaces.
A brass locking button is used to secure the height of each leg.
Press in the locking button to disengage, and turn the leg
slightly so the button is no longer aligned with the holes.
Move the leg up or down to your ideal height setting,
then turn the leg back to align the locking button
with the nearest hole. The locking button must be
fully engaged and protruding through the height
adjustment hole to ensure a positive lock.
Repeat for all four legs, adjusting height evenly or
individually to match an uneven floor surface.
Before use, test that locks are fully engaged
and ensure the chair is stable and resting firmly
on the floor’s surface.
Box Contents and Inspection
Carefully remove all components from the box,
remove all packaging and plastic wrapping and
check items against the list below. Any damaged
or missing components should be reported to your
authorised dealer or Novis Healthcare.
Set Up and Operation (this guide)
Chair frame
4 leg extensions
Assembly
The frame is labelled ‘front’ and back’ to show correct
orientation (high cross bar positioned at the front).
To insert the leg extensions, press in the locking
button and slide the leg extension onto the frame. See
‘Adjusting the height’ to establish ideal seat height for
the user.
With all four leg extensions inserted, place the chair
frame on a flat stable surface. Clip the chair seat to the
frame. Attach the two clips underneath the front of
seat to the higher cross bar, then attach the two clips
underneath the rear of the seat to the lower cross bar.
Ensure the seat is secure before use.
Shower Chair Aluminium
S E T U P A N D O P E R A T I O N
