INSTALLATION INSTRUCTIONS
PART NO. 52-562
LED LOWER AIR VENT
10/3/2011
HONDA GL1500 GOLDWING 1988 - 2000
TOOLS NEEDED: PHILLIPS SCREWDRIVER
10MM SOCKET WRENCH
PLEASE READ THROUGH AND UNDERSTAND THESE
INSTRUCTIONS BEFORE BEGINNING.
INSTALLATION
1.
PARK THE BIKE ON A LEVEL SURFACE
2.
REMOVE THE TWO SCREWS (2A) FASTENING THE
TRIM HOLDER (2B) TO THE BIKE AND REMOVE
THE TRIM HOLDER.
3.
REMOVE THE TWO SCREWS HOLDING THE
LOWER VENT (3A) IN PLACE AND PULL THE VENT
FORWARD TO REMOVE FROM THE
MOTORCYCLE.
4.
REMOVE THE COVER (4A) FROM THE RIGHT
FAIRING POCKET. REMOVE THE FOUR SCREWS
(4B) AND PULL THE FAIRING POCKET (4C) OUT
OF THE FAIRING.
5.
USE THE 10MM SOCKET WRENCH TO REMOVE
THE FOUR BOLTS (5B) THAT HOLD THE
HEADLIGHT (5A) IN PLACE. THE LOWER BOLTS
WILL HAVE A THREADED HOLE IN THE HEAD.
WHEN THE BOLTS ARE REMOVED THE
HEADLIGHT CAN BE PULLED OUT OF THE
FAIRING. THE HEADLIGHT DOES NOT HAVE TO
BE DISCONNECTED FROM THE HARNESS IF YOU
CAN SAFELY REST IT ON THE BIKE WHERE IT IS
OUT OF THE WAY.
2A
Copyright
©
2011 by Big Bike Parts, Inc. No part of
this instruction sheet may be reproduced
without the written permission of Big Bike Parts,
2A
2B
3A
4A
4B
4C
5B
5B
5A
