SPRAYGUN
MATERIAL NOZZLE
NEEDLE
AIR NOZZLE
GROUP
PART N
o
THREAD PART NO CODE BORE PART NO
MAT
L
PART NO CODE AIR CONS
N
100104
BSP
200316
71
0.071”,1.8mm 180123
ST ST
200885
66SD1
(16.2) [27.5]
1
100114
BSP
200338
446
0.046”,1.1mm 180100
NYLON
200850
63PB
(18.9) [32.1]
1
100124
BSP
200315
60
0.060”,1.5mm 180124
ST ST
200885
66SD1
(16.2) [27.5]
1
100125
BSP
200338
446
0.046”,1.1mm 180117
ST ST
200850
63PB
(18.9) [32.1]
1
100126
BSP
200315
60
0.060”,1.5mm 180124
ST ST
200886
66S2
(6.3) [10.7]
1
100135
BSP
200315
60
0.060”,1.5mm 180124
ST ST
200850
63PB
(18.9) [32.1]
1
100176
BSP
200328
2086V 0.086”,2.2mm 180111
ST ST/
200865
67SA
(18.2) [30.1]
4
100188
BSP
200316
71
0.071”,1.8mm 180123
ST ST
200885
66SD1
(16.2) [27.5]
1
Operation Manual:
MODEL 230 PRESSURE/SIPHON FEED
HAND GUN
Important:
Read and follow all instructions and SAFETY PRECAUTIONS
before using this equipment
This is a production hand spray gun suitable for use with most solvent based coating materials. The performance of this gun is
achieved by a range of air nozzles combined with large, smooth flowing air passages and an oversize air valve which gives a lower
pressure drop. The gun is designed to be used with a siphon cup or material feed hose.
IMPORTANT:
These guns are not designed for use with highly corrosive or highly abrasive coating material and if used with such
materials it must be expected that the need for thorough cleaning and/or the necessity for replacement parts will be increased. If there
is any doubt regarding the suitability of a specific material, advise what material is to be used and/or submit a sample for test.
DESCRIPTION
SB-E-A1-2-8
©BINKS 1999
Chart 1
Ordering Information :
TUNG CARB
GROUP 1
Normal range of finishing materials from thin spirits to heavy enamels.
GROUP 4
Vitreous enamel. N.B Air nozzle can only be used with mat. Nozzles of the same group. Suffix “V” denotes tungsten carbide
tipped.
Figure in ( ) brackets is air consumption in c.f.m 63 psi
Figure in [ ] brackets is air consumption in m
3
/ hr at 63 psi
