Binks sv50, Operation And Maintenance Manual

Binks SV50 HVLP 

GraVity Feed SPray Gun 

& toucHuP Gun

Replaces 

Part Sheet 

77-2891   

Part 

Sheet

77-2891R

ATTENTION!

READ BEFORE ATTACHING THE AIR HOSE

HVLP AIR SUPPLY REQUIREMENTS

FULL SIZE GUN: 

30 PSI inlet pressure provides 10 PSI at the air cap. Consumes 12 CFM.

TOUCHUP GUN: 

30 PSI inlet pressure provides 10 PSI at the air cap. Consumes 8 CFM.

NOTE: USE 5/16" OR LARGER I.D. AIR HOSES

SPECIFICATIONS

Max. Air Pressure: 

100psi

For HVLP Compliance:   30 psi inlet pressure delivers  

10 psi air cap pressure

Gun Body: 

Cast Aluminum

Fluid Path: 

Aluminum

Fluid Nozzle: 

Stainless Steel

Fluid Needle: 

Stainless Steel

Air Inlet Size: 

1/4" NPS(M)

OPERATION ANd MAINTENANCE INSTRuCTIONS

Your new SV50 Gravity Feed Spray Gun and Gravity Feed 

Touchup Gun are exceptionally rugged in construction and 

built to stand up under hard, continuous use. However, like 

any other fine precision instruments, their most efficient 

operation depends on a knowledge of their construction, 

operation, and maintenance. Properly handled and cared 

for, they will produce beautiful, uniform finishing results 

long after other spray guns have worn out.

SET-uP FOR SPRAyINg (Figure 1)

CONNECTINg guN TO AIR HOSE

Air should be supplied by a suitable length of 5/16" 

diameter air hose fitted with a 1/4 NPS(f) connection to 

the base of the gun handle. For hose lengths over 50', 

use 3/8" hose.

CONNECTINg gRAvITy FEEd CuP TO guN

Screw the cup into the spray gun fluid inlet. Fill the 

cup with filtered paint.

If desired, attach air adjusting valve with gauge and/or 

quick disconnect to air inlet, then attach hose. Spray test 

and adjust air pressure, fan size, and fluid flow as 

required. Recommended spray distance is 6-8 inches. 

Figure 1

   WarninG

Servicing the gun while pressurized could result in compo-

nents or material exiting the gun at high velocity, possibly 

resulting in personal injury or damage to the spray gun. 

Before removing any components from the spray gun, shut 

off air pressure and drain material from the paint cup.

!

gravity 

Feed 

Cup

Fluid

Inlet

gravity

Feed

Srpay gun

Fan

Size

Control

Material

Flow

Control

Air Hose

    WarninG

A failure resulting in injury or 

damage may be caused by 

pressure beyond top of scale, 

excessive vibration or pressure 

pulsation, excessive instrument 

temperature, corrosion of the 

pressure containing parts or 

other misuse of the air adjusting 

valve with gauge.

!