Please Read and Save this Use and Care Book.
IMPORTANT SAFETY
INSTRUCTIONS
When using your iron, basic safety precautions should
always be followed, including the following:
❍
READ ALL INSTRUCTIONS BEFORE USING.
❍
Use iron only for its intended use.
❍
To protect against a risk of electric shock, do not immerse
the iron in water or other liquids.
❍
The iron should always be turned to the minimum (min)
setting before plugging or unplugging from outlet. Never
yank cord to disconnect from the outlet; instead grasp
plug and pull to disconnect.
❍
Do not allow cord to touch hot surfaces. Let iron cool
completely before putting away. Loop cord loosely around
iron when storing.
❍
Always disconnect iron from electrical outlet when filling
with water or emptying, and when not in use.
❍
Do not operate iron with a damaged cord, or if the iron
has been dropped or damaged. To avoid the risk of
electric shock, do not disassemble the iron; take it to a
qualified service person for examination and repair, or
call the appropriate toll-free number on the cover of this
manual. Incorrect reassembly can cause a risk of electric
shock when the iron is used.
❍
Close supervision is necessary for any appliance being
used by or near children. Do not leave iron unattended
while connected or on an ironing board.
❍
Burns can occur from touching hot metal parts, hot water
or steam. Use caution when you turn a steam iron upside
down or use the surge of steam—there may be hot water
in the reservoir. Avoid rapid movement of iron to minimize
hot water spillage.
❍
The iron must be used and rested on a stable surface.
- When placing the iron on its stand, ensure that the
surface on which the stand is placed is stable.
- The iron is not to be used if it has been dropped,
if there are visible signs of damage or if it is
leaking.
SPECIAL INSTRUCTIONS
❍
To avoid a circuit overload, do not operate another high-
wattage appliance on the same circuit.
❍
If an extension cord is absolutely necessary, a cord rate
at 15-ampere cord should be used. Cords rated for less
amperage may overheat. Care should be taken to arrange
the cord so that it cannot be pulled or tripped over.
SAVE THESE INSTRUCTIONS.
This product is for household use only.
POLARIZED PLUG
This appliance has a polarized plug (one blade is wider than the other).
To reduce the risk of electric shock, this plug is intended to fit into a
polarized outlet only one way. If the plug does not fit fully into the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician.
Do not attempt to modify the plug in any way.
TAMPER-RESISTANT SCREW
Warning: This appliance is equipped with a tamper-resistant screw
to prevent removal of the outer cover. To reduce the risk of fire or
electric shock, do not attempt to remove the outer cover. There are
no user-serviceable parts inside. Repair should be done only by
authorized service personnel.
Note: If the power supply cord is damaged, it should be replaced
by qualified personnel or in Latin America by an authorized service
center.
How to Use
This product is for household use only.
GETTING STARTED
• Remove any labels, stickers or tags attached to the body or
soleplate of the iron.
Note: Use ordinary tap water for ironing. Do not use water processed
through a home softening system.
Important: For optimum performance, let the iron stand for
90 seconds before beginning to iron.
Tip: If unsure of a garment’s fiber, test a small area (on an inside
seam or hem) before ironing.
FILLING WATER TANK
1. Tilt the iron and using a clean measuring cup, pour water into
opening until the water reaches the MAX level mark on the water
tank. Do not overfill.
2. Plug iron into electrical outlet.
SPECIAL FEATURES
Automatic Shutoff in 3 Positions
• Your iron will automatically turn off after 30 seconds of inactivity
if left on its soleplate or on its side. If left vertically on its heel rest,
it will turn off after 8 minutes.
• Once you pick up the iron, the light will turn solid green again once
the set temperature is reached. If the iron is not fully heated, a solid
red light will appear; once the iron is ready, the light will turn solid
green.
Note: Wait for iron to reheat completely before resuming operation.
IRONING WITH STEAM
Steam is produced when you turn the fabric select dial between
settings
●●
and
●●●
.
1. Plug the iron into electrical outlet.
2. Be sure there is water in the water tank.
3. Turn the fabric select dial to appropriate setting for your fabric
(between
●●
and
●●●
). Read garment’s label to help you
determine fabric type.
4. Set the steam/dry selector to desired steam setting.
5. When finished ironing, turn the steam/dry selector to
and
unplug the iron.
Important: Always stand the iron on its heel rest when powered on
or not in use.
SPRAY
1. Be sure the iron is filled with water.
2. On first use, pump the spray button several times.
DRY IRONING
1. Turn the steam/dry selector to
.
2. Turn the fabric select dial to appropriate setting for your fabric.
3. Power indicator light comes on.
4. When finished ironing, make sure to unplug the iron.
Important: Always stand the iron on its heel rest when powered on
or not in use.
Care and Cleaning
This product contains no user serviceable parts. Refer service to
qualified service personnel.
CLEANING
1. Make sure iron is unplugged and has cooled completely. Wipe the
soleplate and outer surfaces with a soft cloth dampened with water
and mild household detergent. Never use abrasives, heavy-duty
cleansers, vinegar or scouring pads that may scratch or discolor
the iron.
2. After cleaning, steam iron over an old cloth to remove any residue
from the steam vents.
STORING YOUR IRON
1. Unplug the iron and let it cool completely.
2. Check that the fabric select dial is set to
.
3. Store iron on its heel rest.
NEED HELP?
For service, repair or any questions regarding your appliance, call
the appropriate 800 number on cover of this book. Please DO NOT
return the product to the place of purchase. Also, please DO NOT mail
product back to manufacturer, nor bring it to a service center. You may
also want to consult the website listed on the cover of this manual.
TWO-YEAR LIMITED WARRANTY
(Applies only in the United States and Canada)
What does it cover?
• Any defect in material or workmanship provided; however,
Applica’s liability will not exceed the purchase price of product.
For how long?
• Two years from the date of original purchase with proof of such
purchase.
What will we do to help you?
• Provide you with a reasonably similar replacement product that is
either new or factory refurbished.
How do you get service?
• Save your receipt as proof of date of sale.
• Visit the online service website at www.prodprotect.com/applica, or
call toll-free 1-800-231-9786, for general warranty service.
• If you need parts or accessories, please call 1-800-738-0245.
What does your warranty not cover?
• Damage from commercial use
• Damage from misuse, abuse or neglect
• Products that have been modified in any way
• Products used or serviced outside the country of purchase
• Glass parts and other accessory items that are packed with the
unit
• Shipping and handling costs associated with the replacement of
the unit
• Consequential or incidental damages (Please note, however,
that some states do not allow the exclusion or limitation of
consequential or incidental damages, so this limitation may not
apply to you.)
How does state law relate to this warranty?
• This warranty gives you specific legal rights. You may also have
other rights that vary from state to state or province to province.
© 2011 Applica Consumer Products, Inc.
2011/5-11-50E/S
When using your iron for the first time, you may notice water
residue inside the unit. This is normal.
is a registered trademark of The Black & Decker
Corporation, Towson, Maryland, USA
Made and Printed in People’s Republic of China
Product may vary slightly from what is illustrated.
LIGHT ‘N EASY
®
AUTOMATIC SHUTOFF IRON
USA/Canada 1-800-231-9786
Accessories/Parts 1-800-738-0245
Register your product at www.prodprotect.com/applica
MODEL
❍
IR0110W
1. Spray nozzle
2. Water-fill opening
3. Steam/Dry selector
4. Spray button
5. Power indicator light
6. 360° pivoting cord
7. Heel rest
8. Fabric-select dial
9. Water tank
10. Soleplate
