Page 1 of 2
Manual Handheld Reader
The SM-200 Handheld reader is a handheld instrument that can read and store data
from both the CMS (Continuous Monitoring System) and PMS (Periodic Monitoring
System) BoltSafe sensors. Reading the PMS sensor requires a probe.
The SM-200 can be used for direct readout during the initial setting of the residual bolt
load in the bolted joint, as well as for subsequent checks. The instrument will read and
display the bolt load data from each sensor on its LCD display. It is possible to choose
between readings in kN or in lbf.
The unit will switch off automatically after 1 minute when no sensor is connected.
By pressing a button, the sensor data is stored in the instrument. This can later be
uploaded to the “BS-Report Generator” program on a PC, and reports can also be
printed. This software is sold separately.
Usage of the Handheld Reader
• The CMS sensor has a connector which connects directly to the SM-200. The
instrument then shows the value of the connected sensor on the display.
• The BoltSafe PMS probe is needed for reading BoltSafe PMS sensors. This probe
energizes the BoltSafe sensor and reads back all data by means of a non-contacting
interface. The probe is connected to the SM-200 with a connector.
• The sensor data is uploaded to a PC by connecting the SM-200 to the PC’s USB
port and transferring the sensor data to the PC. The “BS-Report Generator”
program presents the data for analysis. (Cables and software are available
separately.)
SM-200 Handheld Reader
