INSTALLATION INSTRUCTIONS
8722 Instructions 2-9-15.doc
Page 1 of 6
OEM Lip Mount Camera with Harness and OnStar Mirror for GM
Vehicles with 16-pin Mirror Connector
(Kit part number 9002-8722)
Please read thoroughly before starting installation
and check that kit contents are complete.
Items Included in the Kit:
Tools & Supplies Needed:
Bubble bag containing:
Camera with Mount
Mirror
Mirror Harness
Chassis Harness
Zip lock bag containing:
12 Zip Ties
2 Rubber Well Nuts
2 Bolts
2 sets of T-taps
Zip lock bag containing:
These Instructions
Self-adhesive Template
Phillips Screwdriver
5/16” Drill Bits
7/8” or 22mm Center Hole Saw
Power Drill
Deburring Tool or Round File
Multi-meter or computer safe test light
Wire Crimper
Rust Inhibitor
(Recommended)
Soldering Iron
(Recommended)
Solder
(Recommended)
Plastic Trim Removal Tool
Safety Precautions:
•
Work in a well ventilated area that is clear of obstructions.
•
Secure vehicle with tire chucks in both front and rear of tires.
•
Turn vehicle accessories OFF and ensure ignition key is in OFF position.
•
Wear safety goggles and snug fitting clothes.
•
Use tools only for their intended purpose and which are in good repair.
•
Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions.
For the latest full color instructions, please visit www.brandmotion.com
ATTENTION:
16 Pin Mirror Connector required
-
This kit only works on
vehicles that are equipped with the 16-pin Mirror Connector illustrated on Page 4. Some
GM vehicles with OnStar are equipped with a 10-pin connector. For these applications,
purchase a 10-pin mirror kit BrandMotion part number 9002-8723
For a current list of GM vehicles equipped with a 10 pin connector,
download the latest application guide at www.brandmotion.com/docs2/rvsappguide.pdf
