Trouble Shooting Check List
Problem
Possible Causes
Corrective Action
Compressor will not
run
No power is coming
from the 12 volt
source
Make sure
compressor switch
is on
Power switch is in
off position
Make sure
compressor switch
is on
Blown fuse
Disconnect
compressor from
power source,
replace fuse
- 50 amps
Motor overheated
Let compressor
cool off for about
30 minutes so
thermal overload
switch will reset
Thermal overload
protector cuts out
repeatedly
Lack of proper
ventilation/ambient
temperature is too
high
Move compressor
to well ventilated
area or area with
lower ambient
temperature
Compressor valves
failed
Replace
compressor
Excessive knocking
or rattling
Worn bearing on
eccentric or motor
shaft
Replace
compressor
Cylinder or piston
ring is worn
Replace
compressor
Compressor air flow
lower than normal
or cannot pump to
higher pressures
Worn piston ring or
inlet valves
Replace
compressor
Britpart
, The Grove, Craven Arms, Shropshire, SY7 8DA
www.britpart.com
Specifications
Part number
DA2392
Motor voltage
12 volt
Motor type
Permanent magnetic
Max working pressure
150psi
Max flow rate @ 0psi (13.8v)
150 litres
Continuous use @ 22ºC & 40psi 30 minutes
Max restart pressure
150psi
Max current consumption
45 amps
Built-in fuse
50 amps
Auto reset thermal protection
Yes
Dimensions
280 x 140 x 200mm
Net weight
4.6kg
User Manual
It is essential that you and any other
operators of the product read and
understand the contents of this manual
Save this manual for future reference
Vr1
Portable Air
Compressor
Double Pump
